Ambirad SmartCom3 기술 게시판 - 페이지 3

{카테고리_이름} Ambirad SmartCom3에 대한 기술 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambirad SmartCom3 4 페이지. Control panel & nor-ray-vac radiant system
Ambirad SmartCom3에 대해서도 마찬가지입니다: 매뉴얼 (14 페이지), 설치 배선 (8 페이지)

페이지 인쇄

3. Instructions.

Before commencing any work ensure

that both the gas/oil and electricity

supplies are turned OFF.

1: Remove the four screws securing the original

controls panel to the heater, and withdraw to

reveal the interconnecting wiring.

2: Identify the four cables which run into the

heater (red, blue, black, grey). These should

already be connected to heater terminals 1,2,4

and 6 respectively.

3: Disconnect these four cables from the old

controls.

Wiring diagram

SC3-FM CONTROLLER

4: Connect cables to the new SmartCom FM

terminals as shown in the wiring diagram below.

5: Fit the new SmartCom FM to the heater using

the four screws provided in the kit.

6: Re-instate the gas/oil and electricity supplies.

7: Set up the new SmartCom FM if required

following the instructions in the supplied manual.

8: Test the heater for correct operation.

SMARTCOM TERMINALS

CABINET TERMINALS

LINK