Ambirad TORNADO 설치 및 운영 매뉴얼 - 페이지 10
{카테고리_이름} Ambirad TORNADO에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambirad TORNADO 16 페이지. Gas fired mobile heater
Ambirad TORNADO에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지)
페이지 인쇄The combustion chamber can now be unscrewed.
Slide the burner assembly away from the firing
tube to reveal the burner assembly.
Inspect the burner electrode assembly condition
taking care when reassembling to ensure that the
leads to the assembly are fitted the same way as
on removal. If the electrode assembly is in good
order check the spark electrode gap. This should
be 3.5mm + 0.5mm. Adjust the gap if necessary
by bending the earth rod.
Access to the injector is by removal of the screws
that attach the orifice fixing plate to the burner as-
sembly.
To remove the injector with the burner head
removed, unscrew the injector from its carrier
using a spanner on the hexagon portion of its
body.
When replacing the injector ensure that it is fully
tightened in its carrier using an approved thread
sealant. Replace the sealing gasket if this is
not in good condition.
7.7 Component Replacement
To replace gas safety control valve, follow
instructions for burner maintenance from 7.6.
At previous step, do not remove the injector, but
unscrew the injector carrier and low gas pressure
switch block from the gas valve. The valve can be
replaced and the injector carrier re-fitted using an
approved pipe joining compound.