Aero 31201.030 Installation Instructions

Browse online or download pdf Installation Instructions for Underwater lighting Aero 31201.030. Aero 31201.030 2 pages. Led

Print Page

Installation instructions

1-1.Put the wave tube through the nut and the

rubber plug.

#The wave tube should reach the bottom of

the rubber plug#

4-1.Screw the PG13.5 with the connector on

the wave tube tightly with two wrenches.

4-2.Fix the backcover to the mounting sleeve

by four screw.

7-1.Connect the lighting ﬁxture with the power

cable by the connector .

#fasten the connector tightly to make sure

it can reach IP68.#

7-2.Turn on the power to make sure it is working .

7-3. Fix the light with the mounting sleeve by a

screwdriver.

Low voltage single color ﬁtting:use external power supply,the input voltage of power supply must be

consistent with the requested input voltage of the ﬁtting,as the ﬁtting is constant voltage input type.

The power consumption of power supply must be decided by installer according to the requirements from

the site.

Example of wiring:

100-240V

LED UNDERWATER LIGHTING INSTALLATION INSTRUCTIONS

2-1.Fasten the nut with the screw by using

a tool.

165mm

5-1.Fix the two type"L"bracket on the

mounting sleeve.

5-2.Dig a hole for the installation for each of

the mounting sleeve.

#The distance between these holes and

the ground should less than 1m.#

8-1.Pour the water into the pool after the

installation.

Power(DC24V)

Please read the instruction carefully before installation.

3-1.Put the cable through the wave

tube and the hole of the mounting

sleeve from outside .

3-2.Then insert the cable into the nut/rubber

plug and the screw of the PG13.5.

3-3.Fix the nut with screw of the PG13.5 tightly.

<1m

>165mm

6-1.Put the mounting sleeve into the holes .

6-2. Fasten it with the wall of the pool by a

screwdriver .

<1m