AMCI SD17060B User Manual - Page 15

Browse online or download pdf User Manual for Servo Drives AMCI SD17060B. AMCI SD17060B 20 pages. Stepper drives

Print Page

VERIFYING SYSTEM SETUP

System Checkout

1) Verify all wiring and grounding before applying power to the SD17060B. Make sure the rubber boots are

on the driver's motor and power connectors.

2) Apply 115Vac power. With the motor attached, the power and status LED's should come on green. A

problem exists if either LED does not light, or the Status LED is red. Remove power and refer to the

Troubleshooting section of this manual which begins on the following page.

3) Check for holding torque on the motor. If you have less then you expected, the most common causes are

improper motor current switch settings or having the Idle Current Reduction turned on.

4) The Self-Test feature of the SD17060B allows you to verify your motor wiring without an indexer. With

power applied to the driver, toggle the SB4-1 switch. The motor will begin to rotate clockwise at 60 RPM.

You must remove power from the driver to stop the rotation. If the motor rotates in the counter-clockwise

direction, swap the +B and –B connections. If the motor does not rotate at all, verify your current setting

and the motor's wiring.

5) Have your indexer make a slow move in the clockwise direction for one turn. While the turn is in progress,

the STEP LED should blink. Verify that the motor rotated in the correct direction for one complete turn. If

you are using an optical encoder or other position feedback, verify that the indexer or controller is reading

it properly.

6) Repeat step 4 with a one turn move in the counter-clockwise direction. Again verify that the motor rotated

in the correct direction for one turn.

Any failures at steps 5 or 6 are usually caused by not setting the Pulse Train Input switch cor-

rectly or programming the wrong number of pulses in the indexer profile. If the motor rotates

in the wrong direction you can swap the +B and –B connections instead of altering your pro-

gramming.

7) If you are using the Disable Input, verify its operation with the motor stopped. Note that the motor will have

no holding torque while this input is active and the motor's shaft will be free to rotate.

8) If you are using the Fault Output, verify that it is On (conducting). Remove power from the SD17060B,

disconnect the motor, and re-apply power. The STEP/FAULT LED should be red and the Fault Output

should be off (not conducting).

9) Remove power and re-attach the motor. Power the driver.

10) Consider altering the motor current or enabling the Idle Current Reduction if it is not already enabled.

Lowering the motor current or enabling Idle Current Reduction can greatly reduce motor heating.

20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786

Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com