Flo-Master 24101 Instructions - Page 2

Browse online or download pdf Instructions for Paint Sprayer Flo-Master 24101. Flo-Master 24101 2 pages. Polyethylene sprayer

Print Page

TROUBLESHOOTING

Problem

1. If only air is coming out when you

spray that means that the supply tube

has fallen off or isn't attached correctly.

2. Sprayer is not holding pressure,

check the seals on the pump and make

sure they are lubricated.

(Recommended lubrication is

petroleum jelly.)

3. The sprayer is producing a bad spray

pattern.

CHEMICAL RECOMMENDATIONS

Recommended for use with:

Most chemical weed killers

Most chemical insecticides/pesticides

Mild cleaners (such as dishwashing

detergent, and most disinfectants)

Some sprayers can handle tougher

chemicals. Call or email us for a

recommendation for your project!

1-800-9-SPRAYER/

[email protected]

871-511 Instruction

Instructions for Polyethylene Sprayer 24101 & 24102

If you have any questions or concerns, or missing parts, do not return sprayer to the store.

Call or email Customer Service at 1-800-9-SPRAYER/ [email protected]

Solution

Unscrew and pull the hose off of the tank. Then

unscrew the pump handle from the tank and get

the supply tube out from inside. Reattach the

supply tube onto the hose, insert back into the

tank, and screw the hose back on.

A cylinder O-ring is located at the top of the pump

and needs to be lubricated often. A check/mono

valve is at the bottom of the cylinder and also

needs lubrication. The ﬁ nal seal is on the inside of

the pump.

1. To access this, unlock the pump handle and pull

it out as far as it will go.

2. With a ﬂ at head screwdriver, push down on

the tabs on each side of the pump to release the

locking cap.

3. Pull up on the handle and the plunger assembly

will come out of the pump cylinder. The gasket is

located on the end of the plunger assembly.

4. To reassemble, insert the plunger assembly into

the cylinder and snap the cap back into place.

Check the hose, wand, and nozzle for any clogs.

Clean all these parts properly.

We do not recommend this, or any sprayer, to be used with

the following:

• Flammable Products (gasoline, diesel fuel, hydraulic oil, etc.)

• Hot or Boiling Liquids

• Products containing Acetone/Acetate/Acetic Acid (paint

thinner, some concrete sealers)

• Highly Viscous (thick) materials (tar, high-solid paint or stain

• Paint and Stains

• Products containing Chlorine (Bleach, Pool Water, etc.)

• Strong Acids or Bases

• Strong Solvents

• Lacquers or Lacquer Thinners

• Turpentine

• Epsom Salt

• Mineral Spirits

• Vinegar

• Citrus-Based Cleaner

• Products containing Peppermint Oil or Peanut Oil

1-800-9-SPRAYER

[email protected]

Manufacturing Company