AMCON EQ-6002 User Manual - Page 8

Browse online or download pdf User Manual for Projector AMCON EQ-6002. AMCON EQ-6002 12 pages. Automatic chart projector

Print Page

Automatic Chart Projector - EQ-6002

________________________________________________________________

5. Operating Procedures

Caution: Do not tilt the projector or place in an unstable place. The projector

may topple over, drop or cause injury.

Warning: Connect the power plug to a properly grounded three-prong AC outlet.

If it is connected to an ungrounded outlet, fire and/or electrical shock may result.

Caution: Handling the power plug with wet hands can cause electric shock.

Place the instrument approximately level to the person to be tested. Turn the

power switch 'off'. Insert the power cord into the power socket on the projector

body and plug into the wall outlet. Turn the power switch 'on'. Remove the

battery cover from the back of the remote controller. Insert batteries into the

remote controller as illustrated and replace the battery cover. Adjust the position

of the projector so that the projector light is centered on the screen. Be sure the

projector is in the position from which it will be used. To focus the projector, slide

the focusing knob that is found on the underside of the projector base (on the

same side as the lamp cover). There is a barrel screw that must be loosened

before the knob can be moved. The enclosed Allen wrench can be used to

loosen or tighten this screw.

Turn the projector's power switch on. The chart will automatically reset to the

start position and the lamp will light. When using the remote controller, point the

remote signal emitter in the direction of the remote sensor on the front of the

projector. The switch functions are as follows:

a) Chart Switches - Projects the indicated chart on the switch

b) Light Switch - Turns the lamp off and on

c) Reset Switch - Returns to chart 1 of the program

d) Program Forward Switch - Fowards the program automatically

e) Program Back Switch - Reverses the program automatically

f) Highlight Selector - Isolates chart characters

g) Highlight Transfer Selectors - Moves the isolation of the characters in

the direction indicated. (When the highlighted area of a chart being

projected advances to the maximum or minimum on that chart, the

next or previous chart in the sequence will automatically appear.

Charts can be switched within the same type.)

h) R&G Switch - Applies the R&G filters to the designated charts

i) Program Switch - Refer to the Program Procedure, section 5.3, for

using this function

Note: The projector will automatically turn off if not in use for 5 minutes.