Amcor SF12000E-V2 User Manual - Page 7
Browse online or download pdf User Manual for Air Conditioner Amcor SF12000E-V2. Amcor SF12000E-V2 13 pages.
Print Page
INSTALLATION
Warning：Before using this unit, please keep it upright for at least 3-4 hours.
This unit can easily be moved from one room to another.
While moving the unit please note that it must be kept upright and then placed on an even
surface.
3. Make sure the unit is upright and there are no obstructions
to the air inlet grills.
INSTALLATION OF WINDOW KIT
NOTES
:
•
To ensure efficient operation the opening should be as small as possible.
•
The best form of installation is through a wall duct.
•
Your air conditioner should be used without a vent hose in dry mode. Please ensure an
external water tank is used, monitored and regularly emptied before over spilling.
Permanent plumbing can be also installed in dry mode, alternatively an external water
pump can be fitted for unattended use.
IMPORTANT SAFEGUARDS
The length of the soft hose extends from 28 cm
to 150 cm. If the hose is extended above this
length the unit may malfunction and this can
invalidate the warranty.
The outlet vent must be well ventilated and not
obstructed as this will cause the unit to
overheat. Avoid bending the hose more than
30°.
1. Attach the fishtail connector to
the end of the hose, by
extending the end of the hose
and twisting the fishtail until
firmly attached (At least 3 full
rotations)
2. Attach the other end of the
hose to the exhaust outlet on
the rear of the unit in the same
way.
The window kit (slide bar and fishtail) can be
used with sliding windows and doors. For
other types of window, the fishtail adaptor
should be used on its own.
1.
2. With the hose and fishtail adaptor connected to the
unit, push the end of the fishtail adaptor into the
slot in the slide bar.
7
Partially open the window and then fix
the window kit to fill the opening in the
window.