Amcor D-1000 Manual - Page 3
Browse online or download pdf Manual for Dehumidifier Amcor D-1000. Amcor D-1000 10 pages.
Print Page
HOW THE "AMCOR" DEHUMIDIFIER WORKS
2 4
3
The unit can be supplied with a cord and an earthed plug. If it ever becomes necessary to replace this plug, be sure to
use an earthed plug suitable for the power supply in your area and conform your national safety standard.
The wires of the cable are coloured in accordance with the standard electrical code.
Blue
Neutral
Brown
Live
Green/Yellow
Earth
The blue (neutral) wire should be connected to the terminal in the plug marked N or coloured black.
The brown (live) wire should be connected to the terminal in the plug marked L or coloured red.
The green/yellow (earth) wire should be connected to the terminal in the plug marked E or coloured green or marked
with this symbol:
The unit must be connected to the power supply with the appropriate leads.
The cord should pass through holes with rubber grommets.
Properly fused disconnect switches must be installed between the unit and the power source.
The unit must be wired with an isolation (mains) switch accessible from outside the wet area in which the unit is
installed, to comply with IEE regulations.
The appliance is actually maintenance free, exept in cases
of soiling. In this case the filter has to be cleaned.
1
5
6
ELECTRICAL WIRING
MAINTENANCE
The fan (1) sucks the humid air through the evaporator
(2). There the air is cooled and the moisture in the air
condenses into water. This water is collected in the tray
(3) and drained away through the sump and piping.
The compessor (5) pumps the heat, which has been
extracted from the air, into the condensor (6).
There, this heat is once again released, and absorbed by
the dry air. The ready wired control box monitors and
controls the operation.
3