Floe MAXIS Assemnly Instructions - Page 5

Browse online or download pdf Assemnly Instructions for Boating Equipment Floe MAXIS. Floe MAXIS 8 pages. Extension kit 6-10k

Print Page
Floe MAXIS Assemnly Instructions
STEP 2 (IF INSTALLING MAXIS TILTING CANOPY)
INSTALL (1) ½" X 1 1/4" BOLT AND (1) ½" WASHER INTO EXTENSION TUBE. NOTE THAT THE
EXTENSION TUBE IS SLID OVER THE INSERTS ON THE NON-TILTING SIDE. DEPENDING ON THE
CONFIGURATION, IT IS EITHER ON THE MOTOR SIDE (CORNER POSTS "B" & "C") OR THE LIFTING
SIDE (CORNER POSTS "A" & "D"). FOR EITHER CONFIGURATION, IT IS ALWAYS THE INSERT WITH
TWO THROUGH HOLES (112-01075-00) (FIGURE 2.1). START (1) ½" NYLOCK NUT ON THE ½" BOLT,
BUT DO NOT TORQUE. THEN, SLIDE EXTENSION ONTO INSERT (FIGURE 2.2).
FIGURE 2.1
FIGURE 2.2
SHEET 5 OF 8