Floe SECTIONAL DOCK WEDGE Assembly Instructions - Page 4

Browse online or download pdf Assembly Instructions for Outdoor Furnishing Floe SECTIONAL DOCK WEDGE. Floe SECTIONAL DOCK WEDGE 4 pages. 510-02150-00;510-02155-00

Print Page

STEP 3

- Attach a Safety Quick Connect to the Wedge frame. The position is

predetermined by the bolt hole in the inside of the Wedge. Start by

placing the Wedge in the three installed Quick Connects as shown in

figure 3A. Slide the Safety Quick Connect up onto the Wedge and dock

frame as shown in figure 3B and thread the "T" Bolt into the bolt hole

located on the inside of the wedge making sure that it passes through

the hole in the Wedge and that the Safety Quick Connect is tight

against the bottom of the frame. Mark the location for the Safety Quick

Connect by tracing the outer edges on the bottom of the dock frame.

Refer to figure 3C for detail. Remove the Wedge from the Quick

Connects. Place the connect between the marks and drill a 13/32" bolt

hole using the Safety Quick Connect as a guide. Attach the Safety

Quick Connect to the dock frame as shown in figure 3C using a 3/8 x

2" button head bolt and aluminum nut. Torque to 20 ft/lbs. Place the

Wedge back into the Quick Connects and securley lock into place by

tightening the "T" Bolt in the Safety Quick Connect.

Pre-drilled

Safety Quick

Connect bolt hole.

FIG.

Slide the Safety

Quick Connect

onto frame.

"T" Bolt

Mark the location

of the Safety Quick Connect

by tracing a line on both

sides.

SHEET 4 OF 4

FIG.