Floe 511-00832-00 Assembly Instructions Manual - Page 6

Browse online or download pdf Assembly Instructions Manual for Remote Control Floe 511-00832-00. Floe 511-00832-00 8 pages.

Print Page

Do I need to Erase Current Settings?

At the top of the Circuit Board are the 'Learn Switch', red 'Power LED' light (always on),

and green 'Learn LED' light (on only during programming) . Before reprogramming a

Remote Receiver, decide whether to erase the current settings or not. If replacing a lost

Remote Transmitter Fob but still have another working fob, do not erase the current

settings. The Remote Receiver can store up to 40 settings.

Erasing Current Settings

To erase all current settings, press and hold down the 'Learn Switch' for 15 seconds.

Now when any of the three buttons on the Remote Transmitter Fob are pressed, the

green 'Learn LED' light will flash but nothing will work.

To Reprogram the Remote Receiver:

1. DOWN: *

Press the 'Learn Switch' Once.

The green 'Learn LED' light will flash Once.

Press and hold down the DOWN button on the Remote Transmitter Fob

for four seconds or until the green 'Learn LED' light flashes continuously

and the lift goes DOWN.

2. UP: *

Press the 'Learn Switch' Twice.

The green 'Learn LED' light will flash Twice.

Press and hold down the UP button on the Remote Transmitter Fob for

four seconds or until the green 'Learn LED' light flashes continuously and

the lift goes UP.

3. FLOODLIGHT:

Press the 'Learn Switch' Three Times.

The green 'Learn LED' light will flash Three Times.

Press and hold down the LIGHT button on the Remote Transmitter Fob for

four seconds or until the green 'Learn Light' flashes once and the

Floodlight turns on.

* NOTE: If the Lift is at its' upper or lower limit, the lift will not move past that limit while

reprogramming, but the green 'LEARN LED' light will still flash after 4 seconds

(

this will de-program all existing Remote Transmitter Fobs

to indicate the reprogramming was effective.

SHEET 6 OF 7