AMD AMD 690G Series User Manual - Page 10
Browse online or download pdf User Manual for Motherboard AMD AMD 690G Series. AMD AMD 690G Series 16 pages.
Print Page
Connectors, Headers & Jumpers Setting
3-1 Connectors
(1)
Power
Connector
ATXPWR1
ATX Power Supply connector: This is a
new defined 24-pins connector that
usually comes with ATX case. The ATX
Power Supply allows using soft power on
momentary switch that connect from the
front panel switch to 2-pins Power On
jumper pole on the motherboard. When
the power switch on the back of the ATX
power supply turned on, the full power
will not come into the system board until
the front panel switch is momentarily
pressed. Press this switch again will turn
off the power to the system board.
** We recommend that you use an ATX 12V
Specification 2.0-compliant power supply unit (PSU) with a minimum of 350W power rating. This
type has 24-pin and 4-pin power plugs.
** If you intend to use a PSU with 20-pin and 4-pin power plugs, make sure that the 20-pin power plug
can provide at least 15A on +12V and the power supply unit has a minimum power rating of 350W.
The system may become unstable or may not boot up if the power is inadequate.
(2)
ATX 12V Power Connector (8-pin block) : ATX12V1
This is a new defined 8-pins connector that usually comes with ATX Power Supply. The ATX Power
Supply which fully supports AM2 processor must including this
connector for support extra 12V voltage to maintain system power
consumption. Without this connector might cause system unstable
because the power supply can not provide sufficient current for system.
(3)
PS/2 Mouse & PS/2 Keyboard Connector: KB1
The connectors are for PS/2 keyboard and PS/2 Mouse
.
(4)
USB Port connector: CN3
The connectors are 4-pin connectors that connect USB devices to the system board.
(5) LAN Port connector: UL1
This connector is standard RJ45 connector for Network
10M/100M or 10M/100Mb/1000Mb s data transfer rate
(6) Audio Line-In, Lin-Out, MIC, Surrback, Surround, CEN/LEF Connector: SURROUND1 / CN1
This Connector are 6 phone Jack for LINE-OUT, LINE-IN, MIC, Surrback, Surround, CEN/LEF
Line-in : (BLUE)
Line-out : (GREEN)
MIC : (PINK)
Surrback : (ORANGE)
CEN/LEF : (BLACKNESS)
Surround: (GRAY)
Chapter 3
(24-pinblock)
:
ROW1 ROW2
Audio input to sound chip
Audio output to speaker
Microphone Connector
Audio output to speaker-Rear speaker out
Audio output to speaker-Center/Subwoofer speaker out
Audio output to speaker-Side speaker out
8
ROW1 ROW2
PIN
1
2
3
4
5
6
7
8
9
10
11
12
Pin 1
Pin 1
24-Pin
20-Pin
The
USBLAN1
ROW1
ROW2
3.3V
3.3V
3.3V
-12V
GND
GND
5V
Soft Power On
GND
GND
5V
GND
GND
GND
Power OK
-5V
+5V (for Soft Logic)
+5V
+12V
+5V
+12V
+5V
+3V
GND
support
optional