CNPV CNPV-PS-M-S0010-IEC Installation Instruction - Page 7

Browse online or download pdf Installation Instruction for Solar panel CNPV CNPV-PS-M-S0010-IEC. CNPV CNPV-PS-M-S0010-IEC 16 pages. Crystalline solar pv module

Print Page

TITLE:

IEC INSTALLATION INSTRUCTION

MANUAL FOR THE CRYSTALLINE

SOLAR PHOTOVOLTAIC MODULE

AUTHOR(S):

Bypina Veerraju Chaudary, Yang Xiaowu

12. MODULE WIRING

Each Module has two #12 AWG type standard 90°C sunlight resistant output cables each terminated with plug & ply

connectors. This cable is suitable for applications where wiring is exposed to the direct rays of the Sun. We

recommend that all wiring and electrical connections comply with local regulations.

For field connections, use the minimum No. #12 AWG copper wires insulated for a minimum of 90°C and sunlight

resistant as well. The minimum and maximum outer cable diameters of the cable are 5 to 7mm. Refer to table 1 for

the maximum electrical rating of series fuse.

13. TYPE OF PRODUCT APPLICATION

"The modules are qualified for application class A: Hazardous voltage (IEC61730: higher than 50V DC; EN61730:

higher than 120V), hazardous power applications (higher than 240W) where general contract access is anticipated

(Modules qualified for safety through EN IEC61730-1 and EN IEC61730-2 within this application class are

considered to meet the requirements for Safety class II)"

14. MAINTENANCE

Under most weather conditions, normal rainfall is sufficient to keep the SPV Module glass surface clean. If dirt

build-up becomes excessive, clean the glass only with a soft cloth using mild detergent and water. USE CAUTION

WHEN CLEANING THE BACK SURFACE OF THE MODULE TO AVOID PENETRATING THE SUBSTRATE

MATERIALS. SPV Modules that are mounted flat (0° tilt angle) should be cleaned more often, as they will not ''self

clean'' as effectively as Modules mounted at a 15° tilt or greater. Once a year, check the tightness of terminal screws

and the general condition of the wiring. Also, check to be sure that mounting hardware is tight. Loose connections

will result in damage for array. Changed SPV Module must be the same kind and type. Do not touch live parts of

cables and connectors. Use appropriate safety equipment (insulated tools, insulating gloves, etc.), when touching

them.

Cover the front surface of the SPV Module by an opaque or other material when repairing. The SPV Modules when

exposed to sunlight generate high voltage and are dangerous.

15. SPECIFICATIONS:

See Table1

Notes

Standard Test Condition(STC) of Irradiance of 1000W/m²，AM1.5 Solar Spectrum & 25ºC cell temperature

Nominal Operating Cell Temperature (NOCT): 45±2ºC

The tolerance of Voltage and Current within ±10%

Temperature coefficient of Current is 0.05%/ºK

Temperature coefficient of Voltage is -0.30%/°K

See SPV Module drawing for mounting and grounding holes locations. The drawing for CNPV-xxxxM and

CNPV-xxxxB(Black module) is identical.

Shengli Industry Park, Dongying City, Shandong Province 257000, PRC

http//www.cnpv-power.com

CNPV Dongying Solar Power Company Limited,

E-mail:

[email protected]

TECHNICAL SPECIFICATION

SPEC. NO.:

REVISION:

EFFECTIVE DATE:

Tel: +86-546-7795555, Fax: +86-546-7795777

CNPV-PS-M-S0010-IEC

July 2012

Page 6 of 15