AMD DIrect Pro Series Installation And Operating Instructions Manual - Page 8

Browse online or download pdf Installation And Operating Instructions Manual for Outdoor Fireplace AMD DIrect Pro Series. AMD DIrect Pro Series 20 pages. Round drop in pan fire pits with thermocouple piloted safety ignition (tpsi) & pro brass snowflake burner
Also for AMD DIrect Pro Series: Installation And Operating Instructions Manual (20 pages), Installation And Operating Instructions Manual (20 pages), Installation And Operating Instructions Manual (20 pages)

Valve Assembly
Control Panel
Fig. 4 Removing contents from carton.
The fire pit comes partially assembled from the factory.
The pilot tubing and thermocouple leads are 48" in total
length, therefore, when mounting the Gas Valve/Piezo
mounting plate, ensure the mounting plate is close enough
to make all connections.
Open carton and remove contents. Inspect for any damage
or missing parts.
The hardware bag includes mounting plate screws, orifice,
Piezo wires and flex connector to complete the installation.
Carefully install the fire pit into the prepared enclosure,
connect the gas line and wire according to the figure
drawings in this manual.
INSTALLING NIPPLE INTO BURNER
Before the fire pit is installed:
Install a 2" nipple and flared fitting into the bottom of
the burner. Ensure the nipple has gas rated Teflon tape
wrapped around the threads. Thread the nipple into the
burner in a clockwise manner. Secure into position.
See Fig. 5.
CONTROL PANEL MOUNTING PLATE
The control panel mounting plate is pre-assembled at the
factory with the gas valve and Piezo ignitor. On the back of
this manual is a template for use to cut an opening for the
mounting plate. Once you have determined the location of
control panel mounting plate install the gas connections
and Piezo wires as shown in Fig. 6 and secure all
connections.
Drop In & Flat Pan Fire Pits with Snowflake Burner and (TPSI) Ignition

REMOVING PARTS FROM CARTON

Carton Contents
Thermocouple Lead
Piezo Wires
Pilot Tubing
Hardware
Bag
Nipple
Flared Fitting
Fig. 5 Installing gas line to Pro Burner.
Pilot Tubing
Flex Line To Fire Pit
PAVER-CP-TPSI
(Control Panel)
Fig. 6 Installing control panel into PAVER-CP-MT mounting
plate.
Flexible Gas Line
Burner Pan
Piezo Wires
Thermocouple
Inlet Gas
REV. A
Page 8