Amdi iAdapter 6 Operating Instructions

Browse online or download pdf Operating Instructions for Computer Accessories Amdi iAdapter 6. Amdi iAdapter 6 2 pages.

Print Page

Installation and Operating Instructions for the iAdapter™6

Loosen the 12 (twelve) screws from the back of

the iAdapter™ as shown in the picture below.

These screws are captive screws and will not fall

out after you loosen them and turn the bottom

housing over.

Place the iPad™ onto the 8 (eight) rubber

supports inside the iAdapter™. The rubber

supports are color coded for the different iPad's.

Pink is for iPad versions 2 through 4 with Retina

Display. Green is for the iPad Air and Yellow is for

the iPad Air 2.

Make sure that the reset button of the iPad®

lines up with the reset button of the iAdapter™

as shown in the picture to the right.

Place the top housing of the iAdapter™ over the

iPad®. Align the top housing of the iAdapter™

with the bottom housing of the iAdapter™.

Carefully hold both the top and the bottom

housing of the iAdapter™ together and then turn

it over onto a flat surface. Tighten the 12

(twelve) screws that will hold the iAdapter™

together.