Amdi PARTNER/PLUS FOUR Instruction Sheet - Page 2

Browse online or download pdf Instruction Sheet for Conference System Amdi PARTNER/PLUS FOUR. Amdi PARTNER/PLUS FOUR 2 pages. Augmentative communication devices

Print Page
INPUT AND OUTPUT JACKS:
The PARTNER/PLUS FOUR comes fully equipped with 8 external control jacks (see diagram – BACK VIEW), 4 - Input and 4 - Output. The
four control jacks on the back of the unit correspond to the four message squares on the front of the PARTNER/PLUS FOUR.
INPUT JACKS:
The 4 INPUT jacks labeled J1, J2, J3 and J4 on the back of the PARTNER/PLUS FOUR4 (see diagram – BACK VIEW for jack
locations). J1 is for the first message square on the left. J2 through J4 are for the next 3 message squares to the right. When the switch
plugged into any of the Input jack locations is activated, the messaged programmed into the corresponding message square will play
OUTPUT JACKS:
The jacks marked J1 through J4 on the back of the PARTNER/PLUS FOUR (see diagram – BACK VIEW for jack locations) are
Output jacks used to control low voltage DC devices. When the one of the message squares are depressed, the corresponding jack is
shorted and a low voltage device plugged into that jack will be activated.
PLAYBACK OPERATION:
1.
Turn the PARTNER/PLUS FOUR ON. Turn the VOLUME control switch clockwise, until it clicks ON.
2.
Set the VOLUME control, turning clockwise, until the desired playback volume is reached.
3.
Select one of the 4 message squares on the face of the PARTNER/PLUS FOUR and depress that message square for message
playback.
LEVEL SELECTION:
There are levels for communication on the PARTNER/PLUS FOUR.
1.
To select level 1, slide the switch under LEVELS on the back of the PARTNER/PLUS FOUR to 1.
2.
To select level 2, slide the switch under LEVELS on the back of the PARTNER/PLUS FOUR to 2.
OVERLAY DESIGN AND LAYOUT:
There are several methods you can use to make overlays for the PARTNER/PLUS FOUR.
Draw or print corresponding icons or words on a sheet of 2.9" by 12.5" paper. Section each icon so that it appears in each of the
3.
4 message square cutouts.
4.
Develop your custom overlay using Tech Overlay Designer Software.
Develop your custom overlay using Mayer Johnson's BOARDMAKER™ Software.
5.
Care and Maintenance
The PARTNER/PLUS FOUR is designed to automatically power down after a message is played. However, the power down mode is still an
active mode and drains some power from the battery, affecting battery life. Therefore, if the PARTNER/PLUS FOUR is not going to be used for
a long period (2 to 3 hours) it is recommended that the unit be turned off.
If the PARTNER/PLUS FOUR fails to operate, or operates incorrectly, follow these steps:
1.
Check if the batteries are installed correctly.
2.
Check if the PARTNER/PLUS FOUR is ON and a message has been recorded. Also make sure there are no obstacles blocking
the message membrane switch
3.
Turn the PARTNER/PLUS FOUR OFF for 15 Seconds, then back ON and retry playback.
4.
Replace the Batteries.
5.
For further assistance, feel free to contact our technical support team at 1-866-ERI-7255.
**
LED & Vibrating Feature Options
LED Option: LED will light up when message squares are depressed.
Vibrating Option: The message square will vibrate for a short period of time when it is activated.
95 S
HERWOOD
Farmingdale, NY 11735
A
VENUE
P
: (631) 531-8888
HONE
Fax: (631) 531-8811
.
1-888-353-2634
http://www.admi.net