CO2 Meter CM-1029 Installation Manual - Page 3
Browse online or download pdf Installation Manual for Security System CO2 Meter CM-1029. CO2 Meter CM-1029 4 pages. Industrial siren strobe
Print PageInstallation
1. Determine the desired location and
installation—surface or to a back box.
2. Remove the two screws from the two
tabs that attach the mounting base to
the main unit (See Fig. 1).
3. Squeeze the included base removal tool
and insert through the wiring access
hole in the back of the unit. Release and
pull carefully until the mounting base is
removed from the unit.
4. Remove the base removal tool and turn
the mounting base over to view the
wiring terminals (see Fig. 2)
5. Thread the wires (up to 8 wires,
depending on installation, see "Sample
Applications" on pg. 4) through the
center hole in the base and install the
base to the wall/back box using the four
mounting holes in the base, oriented so
that the engraved arrow is pointing up.
Be careful not to use the hole for the
tamper switch (see Fig. 2).
NOTE:
For non-standard boxes, drill out
any other holes engraved in the
oval indentations on the
mounting base as needed.
6. Connect the wires for the desired
installation to the terminals on the
mounting base as shown in Fig. 3 and
referring to the sample applications on
pg. 4. Note that audio input requires
power to the P.A. (+) terminal.
7. Carefully slide the main unit onto the
base, ensuring the correct orientation
(note the notch and the arrows) and
ensuring the terminal plugs are correctly
engaged (see Fig. 1).
8. Attach the main unit to the base using
the two screws removed in step 2.
Fig. 1
Tamper switch
Tamper
switch
hole
Fig. 2
Orientation
alignment
notch
Fig. 3
Mounting base removal tool
Terminal blocks are on reverse
Mounting holes
STROBE (+)
AUDIO (+)
SIREN (+)
AUDIO (–)
GND
TAMPER
TAMPER
P.A. (+)
Mounting holes
Terminal blocks
AUDIO (+)
STROBE (+)
AUDIO (–)
SIREN (+)
TAMPER
GND
TAMPER
P.A. (+)
Orientation
alignment notch
Tamper
switch
hole
Wiring
access
hole
3