Coalesse E-table 2 Manual - Page 13
Browse online or download pdf Manual for Indoor Furnishing Coalesse E-table 2. Coalesse E-table 2 15 pages.
Print PageLevel top halves
before tightening
Insert the locking sleeves so the notch in the sleeve engages the rounded portion of the draw bolt.
At this time, only install the locking sleeves in those locations that are accessible (the sleeves for the center
bolts will be installed later).
Tighten the nuts using a nail set. Tighten the nuts to the point where they are friction-tight only.
Carefully slide the two connected top halves over to one side, and install the locking sleeves in the remaining
holes as described above. Make sure the top assembly is well supported during this process.
Beginning with the center Tite-Joints, slowly tighten the nuts completely, making sure the center two feet of
the top is leveled and aligned.
Center the top assembly back into the final location on the base assembly, and continue tightening nuts
while leveling and aligning the top sections.
A rubber mallet can used to aid in leveling the top sections, provided that care is taken not to damage the
top.
Page 13 of 15
939500448 Rev E