Coastal Electronic UFRD 360-2 Lockpick Manual - Page 11

Browse online or download pdf Manual for Recording Equipment Coastal Electronic UFRD 360-2 Lockpick. Coastal Electronic UFRD 360-2 Lockpick 15 pages.

Print Page

26.

Before plugging the Lockpick module into the

position. After the module is installed and tested, scroll to the on-screen menu for SETUP and select

FORD for the application and answer whether or not your vehicle already has factory rear seat

entertainment. This will set up the Lockpick for proper picture format and communications.

27. The Lockpick module has several RCA connectors on it for Camera and Multimedia inputs. Plug in

your aftermarket rear, front or both cameras into the Lockpick at this time. Also, additional Video and

stereo Audio Jacks are present for external DVD players, etc. The multimedia A/V input can be used for

sound input only, for a third camera or for full audio + video input from this source.

28. Plug in the iPod docking cable to the Lockpick module. The docking cable will provide all music, video

and communications from the iPod/iPhone/iPad to the Lockpick module. The cable will also provide

charging for your device while your vehicle is turned on.

ADDITIONAL HARNESS CONNECTIONS

29. The plug and play radio connectors connect the radio power to the Lockpick module automatically and

no extra connections are necessary for power or ground. When the vehicle is turned off and the door is

opened, the radio turns itself off and so does the Lockpick module. There is no power drawn by the

Lockpick module when the car is off so it will not drain your battery.

30. The Lockpick harness contains

can allow the interface to monitor when the vehicle is in reverse

camera view. If you are installing a rear camera, connect this wire to a reverse taillight 12V source in

your vehicle (or to the reverse taillight) to signal the interface when the car is in reverse.

31. If you are installing a rear view camera, a 12V power connection is already included in your

LOCKPICK harness to power your camera automatically while in reverse and also whenever you have

selected it with the remote control.

Orange w/Black stripe wire of your Lockpick harness labeled 12V OUT TO

your camera from the vehicle's reverse taillight. Doing so will prevent the Lockpick from being able to

activate and view the camera when the vehicle is not in reverse.

32.

Your Lockpick harness is also equipped with two 12v power outputs that you may use to power low

current devices (1.5 AMPS constant max) such radar detectors, second cameras, small DVD players etc.,

or to control a relay for even larger current items. The 12v ACC power out on the Lockpick harness

(solid RED) will turn off when the car is turned off to prevent battery drain from attached devices. The

Solid YELLOW constant power output will stay powered after the car shuts off.

the Lockpick power outputs to the wiring of your car. This is an output from the Lockpick for your

accessory needs and not an input.

33. There is an additional power output on the LOCKPICK harness labeled 12V FRONT CAMERA

OUTPUT (RED w/BLACK stripe) which you can use to power any second camera you may wish to

install.

34. A BLACK ground wire is included in your LOCKPICK harness which you may use as the ground

connection for your camera(s) or other accessories.

harness, set the dip switches on your module to the all UP

an ORANGE w/WHITE strip wire labeled 12V REVESE INPUT that

Connect the 12v power needs of your rear view camera to the

and automatically switch to a rear

CAMERA. Do not power

Note: Do not connect