10Bar G10 User Manual - Page 5

Browse online or download pdf User Manual for Camera Accessories 10Bar G10. 10Bar G10 10 pages. Camera underwater housing

Print Page

•

IF THE O-RING IS DAMAGED OR SUSPECTED OF BEING DAMAGED, DISCARD IT

IMMEDIATELY.

A spare O-ring is supplied with the housing, or a replacement O-ring can be ordered from 10 BAR. If the

O-ring is contaminated or suspected of being contaminated, clean it with a cotton cloth that is free of all

chemicals or contamination. After cleaning inspect the O-ring again.

• Once the O-ring has been inspected and verified fit for use, apply a small amount of silicone grease to the

O-ring. The silicone grease must be evenly distributed round the O-ring

• Replace the O-ring into the groove; run a finger round the O-ring, to make sure it is snugly seated in the

groove.

4.4 Key-hole Lock

The Key-hole Lock is simple and easy to use and adding security.

To open the housing, turn the levers of the lock perpendicular to the wall of the housing until the lock is

released on both sides.

Pull out the lid by holding on the grip near the lock.

4.5 Mounting the camera in the housing:

Remove the lens cap and wrist strap. Slide the camera into the body along the rubber packing. Make sure the

camera body reach the limit and test the function of the On/Off button on the body of the housing.

Align the bulkhead cable as shown below and check the cable is not jammed under any button or over the

o-ring

Slide the hot shoe plug into the hot shoe