Aktacom ASE-1111 User Manual - Page 5

Browse online or download pdf User Manual for Soldering Gun Aktacom ASE-1111. Aktacom ASE-1111 7 pages.

Print Page

Please Note:

• In the maximum setting (450°C), do not use the soldering

station longer than necessary to avoid excessive stress on

the soldering tip.

• The temperature necessary for soldering has been reached

when the solder melts on the soldering tip.

• Flux is used exclusively for less delicate work to remove

oxides on the soldering joints and to prevent oxidation

during the soldering process.

• If clots form, the temperature is too low.

• If pearls instead of layers form, the soldering tip is dirty.

Clean it with fine emery paper.

Turning the Soldering Station OFF

After work, allow some solder to melt on the soldering tip. This

is to protect the soldering tip during the period of non-use.

Excess solder can be wiped off on the wet cleaning sponge

after reheating for the next use.

• Place the soldering iron in the holder.

• Turn the soldering station OFF with the ON/OFF switch

(position "O").

• Allow the soldering iron and the soldering station to cool

down fully before storing.

Please Note!

If the soldering station is operated without a soldering iron or

with a defective soldering iron, a warning sound can be heard

and the display will flash "ERROR". Plug in or replace the

soldering iron.

The soldering station will remember the last set temperature

after turning off.