Aktakom APS-1305 User Manual - Page 3

Browse online or download pdf User Manual for Power Supply Aktakom APS-1305. Aktakom APS-1305 3 pages. Regulated dc power supply 30v/3a, 30v/5a

Print Page

OPERATIONS

Ensure that the power plug of this unit is connected to a 110V AC power outlet before

using, switch the power ON, and adjust the (8)~(9) knobs to set the voltage to the desired

value, and then plug your output cords into the output terminals (10)~(11), now the current

meter (1) will show the current value.

The limiting value of the output current is 3A or 5A( depending upon the model, you must

disconnect the power immediately when the over load indicator (6) is on.

Setting of current limiting.

Use a short-circuit wire to short the current terminals (+) to (-).

Adjust the current knob untill the CC indicator is on.

Adjust the current knob to the desired value (4) & (5).

Take off the short circuit wire.

SAVETY DEVICE AND MAINTENANCE

You should keep this unit in a dry and well ventilated place after using. Disconnect the

power cord if you will not use the unit for a long period of time.

Do not put device in a moist or wet environment.

This device is designed for indoor use only.

Do use in extreme temperatures, direct sunlight, extreme humidity, or wet environments.

Replace fuse only with the original value fuse, please avoid short circuit of fuse and

holder. The fuse is located on the rear panel adjacent to the power cord receptacle.

Fuse rating is 5A @ 250VAC (5x20mm).

Do not block the ventilation holes in the rear and side panel, as this will increase the

internal temperature.

Please keep this device out of the reach of small children.

Do not put any liquid near the unit to avoid short circuit.

10.

Do not place the system near strong magnetic fields.

11.

Before operation the system must be temperature stabilized to avoid condensation.

12.

Opening of the system and service must be performed by qualified service personal.

13.

Ground the chassis by only using a three-contact AC power cable which must be

plugged into an approved three-contact electrical outlet, and do not attempt to defeat the

ground wire connection or float the device, to do so may pose a great safety hazard.

14.

Clean and recalibrate the equipment on a regular basis to keep the equipment

looking nice and working well.

15.

Remove dirt & dust on the outside cover with a dry cloth whenever it becomes

noticeable.

16.

If the equipment ever becomes inoperative or damaged, refer servicing to a

qualified repair facility.

17.

Pay attention to warning-signs printed on the unit.

Protective ground terminal

Only connect this unit to a socket with grounded neutral conductor.

ACCESSORIES

This instrument is supplied with the following accessories:

Power cable ............................................................. 1pcs

Operation manual .................................................... 1pcs