Aktakom ASE-1119 User Manual - Page 4

Browse online or download pdf User Manual for Soldering Gun Aktakom ASE-1119. Aktakom ASE-1119 4 pages.

Print Page

2. The first time you use the solderhg iron, it may smoke slightly as

the heating element dries out. This is normal and should only last for

approx. 10 minutes.

3. Never ﬁle the specialy-plated tip.

3. MAINTENANCE

This tool must be placed on its stand when not in use.

If the supply cord is damaged, it must be replaced by the

manufacturer or its service agent or a similarly qualiﬁed person in

order to avoid hazard.

TIP REPLACEMENT

Note: Tip replacement or cleaning should be done only when the iron

is at room temperature or below. The tip can be changed or replaced

simply by unscrewing the knurled nut barrel assembly.

The station must be switched off and allowed to cool before and

during this operation, as damage may occur if the system is left on

without the tip inserted, after removing tip, remove any oxide dust that

may have formed in the tip retaining area of the barrel. Be careful to

avoid getting dust in your eyes. Replace the tip and screw the

retaining knurled nut barrel assembly using only hand pressure to

tighten. Pliers should only be used to tighten the nut if loosening occur

when the iron is hot to avoid burning your fingers. Do not over tighten

as this would damage the element.

GENERAL CLEANING

The outer case of the iron or station may be cleaned with a damp

cloth using small amounts of liquid detergent. Never submerse the

unit in liquid or allow any liquid to enter the case of the station. Never

use solvent to clean the case.

1. The appliance is not a toy, and must be kept out of children's

hands.

2. Before cleaning the appliance or changing the ﬁlter, always remove

the power lead plug from the socket. Unserewing the housing is not

permitted.

3. This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental capabilities, or lack

of experience and knowledge, unless they have been given

supervision or instruction concerning use of the appliance by a person

responsible for their safety.

4. If the supply cord is damaged, it must be replaced by the

manufacturer or its service agent or a similarly qualiﬁed person in

order to avoid hazard.