Aero-Spa AP 1000 Installation Manual - Page 8

Browse online or download pdf Installation Manual for Hot Tub Aero-Spa AP 1000. Aero-Spa AP 1000 12 pages.
Also for Aero-Spa AP 1000: Installation Manual (13 pages)

Print Page

pressing the "reset" button does not start the equipment,

unplug the extension cord and press the "reset" button. If the

"reset" button does not "hold in", replace the GFCI breaker. If

the button does "hold in", plug the ex-tension cord into the

GFCI breaker and unplug the equip-ment from the other end.

Press the "reset" button. If the "reset" button does not "hold

in" replace the extension cord. If the "reset" button does "hold

in" contact Aero-Spa™. Note: Do not operate this equipment

without a GFCI breaker installed. TIP: In the event of a power

outage, the GFCI device will need to be reset manually.

b) The equipment will begin to operate. You will hear a faint hum

from the generator and a steady bubble stream will be

emitted from the diffuser.

c) Adjust the timer to operate 2 hours of run time 2 times per

day. Adjust the timer based on your use habits. Reducing the

run time while maintaining water clarity will maximize the

equipment life and minimize power consumption.

This product has no user serviceable parts. If service is required, call

or return the product to an authorized service representative.

Attempts to service the ozone generator will void the customer

satisfaction policy and Limited Warranty and expose the user to

electrical shock which may cause severe injury or death. Keep the

area around the product free of leaves and other debris. If debris

enters the product through the air intake holes, unplug the product

and carefully remove the debris. Restart product (see section 3)g).

Fill & Start-Up Recommendations

Our customers have been using the Aero-Spa™ system as the

primary water treatment process for years without harsh chemicals.

Because we cannot control how your hot tub is used/maintained and

according to the EPA we must recommend maintaining at 1 – 2 PPM

of an approved residual sanitizer to minimize cross contamination of

users. To put this into perspective, to obtain a 1 PPM ratio in a 500

gallon hot tub, you would need to add about 0.63 OZ (1.25

tablespoons) of regular household bleach (6% sodium hypochlorite).

Maintenance and Care