Aero-Spa AP 1000 Installation Manual - Page 10

Browse online or download pdf Installation Manual for Hot Tub Aero-Spa AP 1000. Aero-Spa AP 1000 13 pages.
Also for Aero-Spa AP 1000: Installation Manual (12 pages)

Print Page

This is normal when the water used to fill the hot tub has high iron

content. Using "rust or stain remover" solution, wipe the rust stain with

damp sponge containing rust or stain remover. Rinse sponge in

solution periodically.

This occurs when the water used to fill the hot tub is hard. Using a

sponge or "Scouring pad" pad, wipe surface to remove scale. Care

should be used if using a "Scouring pad" pad to ensure the surface of

the hot tub is not damaged. Recommend use of calcium or scale

controller to lower Calcium Hardness

Light brown material on surface of hot tub walls

This occurs when the water is not adequately circulated in the hot tub.

Using a sponge, wipe surface to remove scale.

1. Increase hot tub circulation pump cycle time. Synchronize

circulation pump and Aero-Spa run time.

Water is normally clear but turns cloudy during or just after use

1. Increase the cycle run time by 25%

2. If these steps do not solve the problem within (4) days,

contact Aero-Spa, LLC

Water back siphoned into the ozone tube and or the ozone

1. A small amount of moisture can be considered normal in high

humidity conditions and in such a case nothing needs to be

done. If there is more than a few drops proceed to step 2.

below

2. Turn off all power by unplugging Aero-Spa from the 120 volt

power outlet. Remove the sintered diffuser from the hot tub

and lay it on the ground at a lower elevation than the

generator. Allow the unit to purge the water from the ozone

tube. When complete, reinstall sintered diffuser in hot tub

and make sure the air line is installed as described in the

installation procedure.

3. If these steps do not solve the problem call Aero-Spa, LLC

Brown ring at water line

Light scale on surface

generator