Aktino AKCUTR User Manual

Browse online or download pdf User Manual for Network Hardware Aktino AKCUTR. Aktino AKCUTR 2 pages. Tracer cards

Print Page

The AK500TR Tracer card is used to provide metallic access to the AK500S chassis MSPAN outside plant pair

connectors. The AKCUTR Tracer card is used to provide metallic access to the AK5xxCU Compact CO Unit and

the AK5xxRU Compact Remote Unit. This allows metallic testing of the entire copper span being used for

deployment of an Aktino system.

AK500TR Tracer Card

Figure 1 AK500TR Tracer Card

Use AK500 lines

(Ignore AK150 lines)

AK500TR & AKCUTR Tracer Cards

Users Manual

To install the AK100TR Tracer card, slide the card

into the AK500S chassis (see Figure 1).

Power (-48Vdc) is not required. The AK500TR

exposes the outside plant wires to the user. Test

equipment used with the tracer card should provide

adequate OSP protection. Voltages applied to the

tracer card connectors should not exceed 60V. The

tracer card does not provide current limiting. Currents

should be limited to less than 1A. Remove all

connections on the tracer card before inserting or

removing the card from the AK500S chassis.

Posts are available for each of the 12 MSPAN tip and

ring pairs on the end of the AK500TR card. See

Figure 2 for details.

The AK500TR Tracer card is not intended to remain

in the chassis for extended period; it should be

removed when testing is completed. To remove the

AK500TR Tracer card, grab the pull tab located at the

top of the card and pull the card straight out.

Odd and Even refer to AK500S slot number

Numbers are pair connections on the AK500S

back panel Amphenol connector

RING

Figure 2 AK500TR card edge

Pair access posts

TIP

Document 180-0042-001 R00