Aktobis WDH-AP1101 Manual - Page 6

Browse online or download pdf Manual for Air Cleaner Aktobis WDH-AP1101. Aktobis WDH-AP1101 11 pages.

6.) Air sensor mode (Auto Mode)

Press the "AUTO" button. The air sensor switches on and automatically starts measuring the air quality. There are

4 possible results of the determined air quality (see diagram below):

Please note that the correct air sensor function is only available after one minute !

If the determined air quality is "very good", the air purifier automatically switches to a weak fan speed. If the result

is opposite and the air quality is poor, the air purifier switches to a higher fan speed (medium, high or turbo).

Adjustment of the air sensor

The air sensor is located on the side in a small compartment and reacts to particles in the air, thus always reflecting

only one air quality trend. As it is a trend (similar to a weather station), this function cannot provide a 100% reliable

statement about pollutants in the room air or over the entire area of a room.

In addition, there may occasionally be greater fluctuations in operation (jump from red to green and vice versa) as

the air sensor reacts to particles and volatile organic compounds (VOCs) in the room and is also exposed to

draughts.

To adjust the air sensor, press the "FILTER" button for approx. 3 seconds. This causes the wave display above the

"FILTER" key to start flashing. By repeatedly pressing the "FILTER" key, you can now change the sensitivity of the

air sensor (see diagram below):

Standard

Sensitive

Very sensitive

To quit the air sensor adjustment, wait approx. 10 seconds and the settings made will be saved.

To ensure that the new settings are accepted correctly, it is necessary to switch the unit off and on again !

Cleaning the air sensor

We recommend that you clean the air sensor approx. every two months to ensure trouble-free air sensor operation

(Auto Mode). First use a soft brush to clean the air slots above and below the air sensor compartment. Then open

the air sensor compartment. Now clean all areas of the black plastic box. Please use a soft (damp) cotton swab for

this purpose in order to clean the inlet, outlet, and sensor, and a dry cotton swab to remove any water residue from

the sensor. Finally, close the air sensor compartment again. (See diagrams below.)

Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany

www.AKTOBIS.de