Akura ADLTDVD3233 Quick Start Manual

Browse online or download pdf Quick Start Manual for LCD TV Akura ADLTDVD3233. Akura ADLTDVD3233 2 pages.

Print Page

GETTING STARTED

Please read the safety section (page 2) in the main instructions before proceeding further. This section

contains vital information to ensure safe positioning and use of the TV

Unpack the TV and place on a flat level surface suitable to support the weight of the TV (26.4 kg approx.). This will

require two persons to lift the TV safely. Remove the plastic film protecting the LCD screen

Connect the aerial into the TV Tuner connector at rear of the TV (Fig 2).

Fig 1

Connect the mains power lead to the mains socket at the rear right side of the

TV. Plug in and switch on at the mains and the switch at the front lower right

corner of the TV. The LED indicator on the TV will illuminate and show red (Fig

1).

Open the battery compartment cover (Fig 3) on the reverse of the remote

control. Insert 2 x AAA 1.5V alkaline batteries in accordance with the diagram in

the battery compartment. Take care to observe the correct polarity (+/-). Refit

the battery compartment cover

Press the POWER button (Fig 4) to turn the TV set on. The LED indicator will

turn green and after a few seconds, the screen will activate and the first time

installation menu (Fig. 5) will appear.

Use the cursor ▼/▲ buttons on the remote control to move up and down the

display to highlight desired options.

The default language is "English" if you want another language select that

language using the ►/◄ buttons and press ENTER.

Select OK and press ENTER. The TV will now search the entire UHF range for

both digital and Analog TV stations. See Fig 6. When search is complete the TV

will display the first channel (BBC1) in DVBt

Fig 7 will be displayed.

WATCHING TV (basic operation)

10.

To select a channel either enter the number of the channel using the number

buttons on the remote control or scroll through the channels using the channel

CH+/- buttons.

11.

To view analogue TV channels press the SOURCE button to display the source

menu. Using the cursor ▲ / ▼ buttons highlight TV on the menu and press

ENTER to select. To view digital TV channels select DTV on this same menu.

12.

To check the list of channels stored, press the ENTER button to display the

channel list and use the cursor ▲ / ▼ buttons to move up and down the

display. To select a channel, highlight the channel on the list and press ENTER

to confirm.

13.

Adjust the volume to the desired level using the volume or cursor ◄ / ►

buttons. The sound can be silenced by pressing the MUTE button on the

remote control and a mute symbol will appear on the screen. Press the MUTE

button a second time to restore the sound.

14.

To switch off the TV for short periods, press the POWER button. The TV will

go into standby mode and the LED indicator will change to red. If not using the

TV for extended periods turn off at the mains switch to conserve electricity, all

settings will be retained.

ADLTDVD3233

Quick Start Guide

mode.

If you Cancel the procedure

Fig.2

Fig.3

Fig.4

Fig.5

Fig.6

Fig.7