American Standard 2275.509 Installation Instructions Manual - Page 3
Browse online or download pdf Installation Instructions Manual for Plumbing Product American Standard 2275.509. American Standard 2275.509 6 pages.
Print Page
7
ATTACH CABLE CONNECTOR
Thread CABLE CONNECTOR (1) clockwise
onto DRAIN BODY CONNECTION (2) and
hand tighten. Fig. A.
Your new POP-UP DRAIN installation is
now complete. Fig. B.
Note: Tailpeice on pop-up drain is 1-1/4" O.D.
Fig. B.
8
CHECK OPERATION OF POP-UP
Operate LIFT KNOB (1) to verify that STOPPER (2) opens and
closes.
Note: If STOPPER (2) does not open and close properly then
refer to the "troubleshooting section" of these instructions.
9
9
MAKE WATER SUPPLY AND WASTE CONNECTIONS
NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS NOT INCLUDED
AND MUST BE PURCHASED SEPARATELY.
Connect water supply to INLET SHANKS (1) with 1/2" IPS
FLEXIBLE SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3).
Use adjustable wrench to tighten connections. Do not over
tighten. Be careful not to kink copper supply when bending.
Use tubing cutter to cut to proper length.
Connect HOT water supply to inlet of left SHANK and COLD
water supply to right SHANK using sealant, appropriate
connectors, and COUPLING NUTS.
Connect 1-1/4" O.D. TAILPIECE (4) on POP-UP
DRAIN to
"p" trap.
Fig. A.
1
2
1
COUPLING
NUT ON FLEX
SUPPLIES
2
FLEXIBLE
SUPPLIES
"P" TRAP
HOT
3
Fig. B.
2
3
3/8 O.D.
BULL-NOSE
RISERS
COUPLING
NUT WITH
FAUCET
COMPRESSION
NUT
4
COLD
3/8 COMPRESSION
CONNECTION
M 9 6 8 8 7 6 R e v. 1 . 2
1-1/4" O.D.
1
FERRULE