BOBPERRY AUDIO Ducker Pro 2 Manual - Page 16

Browse online or download pdf Manual for Monitor BOBPERRY AUDIO Ducker Pro 2. BOBPERRY AUDIO Ducker Pro 2 18 pages.

Print Page

Bob Perry Ducker Pro 2 – Manual – Page 16/18

5) Set Attack, Hold and Release to very short values. (around 5 ms)

6) You can use the Lookahead for values shorter than your Attack time to make sure you

catch every sibilance.

7) Adjust the Range. Values between -3 and -6 dB are "normal". Sometimes you have to use

higher values if you are using a cheap condenser mic with a lot of high frequencies.

Note: If you have a Stereo track with mixed music you can do de-essing but it's a little bit less

straight-forward. Try the M/S feature:

Usually the Vocals are in the center (Mid) of the mix. Switch the M/S modes of the Main and

Aux to "MID". Now you only process the center of the mix without touching the side signal.

5) Pumping Remix of a mixed Stereo Track

For a very quick solution of a pumping remix you can use the M/S Matrix and filters to detect

only the Bass Drum hits of a stereo track to trigger the Ducker.

Set up the Ducker Pro 2 like we described for de-essing. But instead of filtering the low

frequencies, filter the high frequencies.

Use the Hi Cut and set it to around 50-80 Hz. Now you have only very deep Bass Signals. Try

to isolate the Bass Drum from the Bass (Instrument) and set the Threshold and other

parameters.

VST is a software and trademark of Steinberg Media Technologies GmbH.

20210113160816