Euro-Pro ULTRA SHARK UV627 Owner's Manual - Page 4

Browse online or download pdf Owner's Manual for Steam Cleaner Euro-Pro ULTRA SHARK UV627. Euro-Pro ULTRA SHARK UV627 6 pages. 7.2 volt dc 3-speed cordless sweeper

Print Page

Euro-Pro ULTRA SHARK UV627 Owner's Manual

ASSEMBLING YOUR CORDLESS SWEEPER

Before you start:

Your Cordless Sweeper will require very little assembly. You should remove it from the

carton and familiarize yourself with all the components listed as per the exploded view

drawing (pg.2) This will help you in the assembly and operation of your cordless

sweeper.

Note: The charging adapter and the lower handle are shipped inside the dust cup.

Fig. 1

In the event that the edging tool is not attached to the sweeper, insert the edging

tool into the "square" hole under the bottom of the sweeper power head. Gently

but firmly push until the edging tool locks into place. (Fig. 1)

Insert the lower handle - small end - into the sweeper power head. Push until

firmly in place. (Fig. 2)

Assemble the extension tubes by pushing the plastic insert into the mating extension

tube. (Fig. 3a) Push until only small portion of insert is visible or you cannot press

any farther into the tubing. Push the extension tube assembly into the upper handle.

(Fig. 3)

NOTE: One extension tube has a different plastic insert. This tube should be

on the bottom of the handle.

Insert the extension tube assembly into the lower handle so that the tab on the

plastic insert snaps into the open slot on the lower handle. (Fig. 3b)

Place the handle into the upward storage position.

Plug the charging adapter into the sweeper power head charging jack or plug the

charging adaptor into the charging jack of the charging stand. If using the charging

stand, place the sweeper onto the charging stand to charge. Plug the charging

adapter cord into a standard electrical outlet (120V, 60Hz.) The red charging

indicator should illuminate. If it does not, depress the On/Off switch one time.

Insert into Lower

Handle

Fig. 3a

CAUTION: ALWAYS USE ADAPTOR SUPPLIED (ONLY)

WITH SWEEPER

Lower Handle

Fig. 2

Fig. 3

Fig. 3b

Battery Removal & Disposal

NOTE:

If uncertain as to how to remove your battery pack, we suggest

you take your sweeper to a reputable small appliance service

technician to have this service performed.

Follow these steps when battery removal is required.

This sweeper is equipped with Ni-Cd batteries and you need to dispose of them

properly. When the batteries are no longer good for use, they must be removed from

the sweeper for disposal. Do not remove the batteries for any reason other than

disposal of them. The batteries must be recycled or disposed of in accordance

with local regulations. Please consult your Yellow Pages or local recycling

center for more information.

WARNING:

You must never use ordinary batteries for replacement as these

may leak and cause damage. Use only battery pack XBP615

for replacement.

Removal of Battery Pack

Remove the extension tube and dust container.

Turn unit over so that the base is facing upwards. Be careful NOT to turn the unit

ON. (Fig. 19)

Push in locking tab and lift off battery assembly. (Fig. 20)

Place battery assembly aside.

Insert the new battery assembly into unit. Ensure that locking tab snaps in place.

CAUTION:

This appliance contains Ni-Cd batteries. The batteries must

be recycled or disposed of in accordance with local

regulations. Please consult your Yellow Pages or local

recycling center for more information.

Fig. 19

Fig. 20