Akura APTCDC832PR Instruction Manual - Page 15

Browse online or download pdf Instruction Manual for Micro Music System Akura APTCDC832PR. Akura APTCDC832PR 16 pages. 3cd cassette player micro system

Print Page
Should you experience problems please consult the guide below
Symptom
Dead. No led lit
Dead. Red led lit
No output. Display lit
Poor reception. FM
Poor reception. AM
Not playing
Disc tray not opening
Tape not playing
Tape "Wowing"
Poor high frequency response
Record button will not press
No operation or intermittent
If you are still having difficulty please call the Technical help line. Ring 01422
203676 (Normal rates apply).
Opening hours Mon-Fri 8 am – 8pm. Sat 9 am – 4pm. Sun 11am – 4pm "Bank
holidays as Sun"

Trouble Shooting Guide.

Possible Cause
General
No power to unit.
Unit is in standby
Volume set low
Incorrect mode set
AUX input selected
Speaker leads not connected
correctly
Radio
Aerial wire not unravelled.
Signal in your area may not be
strong.
Loop aerial not adjusted
CD
Disc not placed correctly
Not correct type of material
Disc dirty or damaged.
No disc in selected location
Laser optic dirty
CD not selected
Tape
Tape not selected
Old tape or tape tightly wound
Dirty tape heads
Pre recorded tape in or tabs
removed
Remote Control
Exhausted batteries
Objects in path of signal
Page 13
Remedy
Check mains connection
Is plugged in and turned on
Press standby button on main
unit or Power button on R/C
Adjust volume level
Check Mode and select correct
one for your needs
Select CD /Radio/Tape
Ensure the wire ends are
gripped by the metal clips
Fully extend FM wire aerial.
Consult your local dealer
Rotate the loop aerial for best
reception
Ensure disc is Label side up.
This player will not play MP3
discs.
Clean disc with care see page
14
Press disc select button
Use a Laser cleaning disc from
your local supplier.
No CD operation if CD is not
selected
No Tape operation if Tape is
not selected.
Fast wind tape to loosen
Clean tape heads with a "Head
Cleaning" cassette.
Place a blank tape and check
that tabs have not been
removed
Replace batteries
Clear optical path to receiver