American Standard 2171 Installation Instructions - Page 3

Browse online or download pdf Installation Instructions for Indoor Furnishing American Standard 2171. American Standard 2171 4 pages. American standard monoblock lavatory faucet single lever installation instructions

Print Page
4
TEST INSTALLED FAUCET
AND CHECK FOR LEAKS
With HANDLE (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3).
Operate HANDLE (1) to flush water lines thoroughly.
Replace AERATOR (3).
4a
CHECK DRAIN CONNECTIONS
Operate LIFT ROD (4) and fill lavatory with water. Check that
DRAIN STOPPER (5) makes a good seal and retains water in
lavatory. If necessary adjust stopper height by repositioning
LIFT ROD (4) and tightening Thumbscrew (6).
Release DRAIN STOPPER (5) and check all drain connections
and "P" trap for leaks.
5
ADJUST HOT LIMIT STOP
By restricting HANDLE rotation and limiting the
amount of hot water allowed to mix with the cold, the
HOT LIMIT SAFETY STOP (5) reduces risk of accidental
scalding. To set the maximum hot water temperature
of your faucet, all you need to do is adjust the setting
on the HOT LIMIT SAFETY STOP (5).
Remove PLUG BUTTON (1). Loosen HANDLE SCREW (2)
and pull off HANDLE (3).
Pull off CARTRIDGE CAP (4).
Use a flat blade screwdriver or your fingers to pull up
and rotate red HOT LIMIT SAFETY STOP (5). Follow
Step "A" or "B" to adjust min./max. discharge
temperature. "0" being the hottest to "7" the coldest
temperature setting. Factory set at "0".
Replace CARTRIDGE CAP (4) and HANDLE (3). Tighten
HANDLE SCREW (2). Replace PLUG BUTTON (1).
Tighten if necessary.
"B"
PRY RED RING FORWARD
AND ROTATE CLOCKWISE
"B"
ADJUSTMENT WHEN
WATER IS TOO COLD
4
HOT
1
2
"A"
PRY RED RING FORWARD
AND ROTATE COUNTER-
CLOCKWISE ONE CLICK
TEMPERATURE
SETTING NUMBERS
"B"
"RED RING"- HOT
LIMIT SAFETY STOP
1
3
6
5
"P" TRAP
COLD
2
3
4
"A"
"A"
ADJUSTMENT WHEN
WATER IS TOO HOT
6
5
M 9 6 8 2 9 1 C