Akurat lighting W-DMX User Manual - Page 2
Browse online or download pdf User Manual for Control Unit Akurat lighting W-DMX. Akurat lighting W-DMX 2 pages.
Print Page
AWTRX-1 G5
W-DMX Transceiver TX/RX
User Guide
Configuration in TX mode
1. Set RX/TX DIRECTION switch (2) to TX (ON)
2. Connect the DMX signal to DMX Input (1)
3. Connect the power source to DC INPUT (7)
4. Set ON-OFF switch (8) to ON
WARNING!
In TX mode transceiver transfer the DMX signal only to previously paired receivers.
See below the instruction of pairing transmitter and receivers.
Configuration in RX mode
1. Set RX/TX DIRECTION switch (2) to RX (OFF)
2. Connect the fixture/fixtures to DMX Output (1) using DMX cable
3. Connect the power source to DC INPUT (8)
4. Set ON-OFF switch (9) to ON
WARNING!
In RX mode transceiver accepts the DMX signal only from previously paired W-DMX TX transmiter.
See below the instruction of pairing transmitter and receivers.
The status of transceiver in TX mode - blue STATUS LED (4)
The status of transceiver in RX mode or status of receiver (4)
AWRX-1 G5
W-DMX Receiver RX
User Guide
1. Connect the USB plug to USB socket in DMX terminal of fixture.
2. Be sure that the ON-OFF switch is set to ON position.
3. Remove the liners from Velcro tapes and stick the receiver to the housing of fixture.
The state of receiver indicated by blue STATUS LED (4) - see above
The red MODE/SIGNAL LED (5) shining steadly indicates that RF signal is O.K.
If it starts to flash the RF signal may be to low.
WARNING!
Reciver accepts the DMX signal only from previously paired W-DMX TX transmitter.
Instruction of pairing transmitter and receivers
PAIRING - press the LINK button (6) on transceiver for 1 to 2 seconds to pair in all of unassigned receivers.
UNPAIRING receiver - press the UNLINK button (12) in receiver for more than 3 seconds to unpair it.
UNPAIRING all - press and hold more than 3 seconds the LINK button (6) on transceiver and then release it to unlink all paired receivers.
WARNING!
Before pair in the receivers have to be in a status „not assigned to a transmitter" (blue STATUS LED continuously Off).
W-DMX
www.akurat.lighting
Description of the operating elements:
1. DMX input/output (XLRs)
2. RX/TX DIRECTION switch
3. POWER indicator (green)
1
4. STATUS indicator (blue)
5. MODE/SIGNAL indicator (red)
6. LINK BUTTON
7. AERIAL
8. DC INPUT
9. ON-OFF SWITCH
On 900ms/Off 100ms = no DMX present
Continuously On = DMX present
On 100ms / Off 100ms = linking receivers
On 500ms / Off 500ms = unlinking all receivers
Continuously Off = not assigned to a transmitter
On 900ms/Off 100ms = assigned to a transmitter, but no DMX present
Continuously On = assigned to a transmitter and DMX present
On 100ms / Off 100ms = link to transmitter lost or linking to transmitter
e-mail:
2
4
3
5
6
3
12
10
11
Description ... (continuation):
3,4,5,7 -see the description above
10. USB cable - DC Input/DMX Output
11. ON-OFF SWITCH
12. UNLINK button
+48 22 863 64 33
tel/fax:
8,9
7
4
7
5