Domus 66002 Installation Manual - Page 2

Browse online or download pdf Installation Manual for Lighting Equipment Domus 66002. Domus 66002 2 pages.

Print Page
Surface Mounted
3 Fix the batten base onto the required place
with screws.
5
5.Fasten terminal A between driver and LED MODULE；Snap LED MODULE back to BATTEN BASE;
Make sure all Spring Connector A are in place to securely hold LED MODULE to BATTEN BASE.
7
7.Turn on the power supply.
Suspended
1
Warning:
If the product is not installed as per the Installation Manual, then the warranty and liability for the product will
be voided.
Note:
-The lamp must be installed by professional electrician
-Ensure the power supply is switched off before fitting this product
4.Individually connect the Live wire,Neutral wire and Earth wire into the terminal block; Set the driver switch
to desired setting,and default driver setting is "I" mode.
Spring Connector A
2
Dual Power Switch:
I-High power
O-Low Power
29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
Phone: 02 9554 9600
Terminal A
-Do not touch the lamp when in use
-Keep away from hot steam and corrosive gas
E
L
Terminal block
|
Fax: 02 9554 9433
|
www.domuslighting.com
Installation Manual
6
spring connector B
6.Push caps back to Batten
Base until it catch the spring connector B .
3