Domus 25056 Installation Manual - Page 2

Browse online or download pdf Installation Manual for Spotlight Domus 25056. Domus 25056 4 pages. 15w spotlight with sensor, black finish (trio)

Print Page

Installation

1. Installation by a licensed electrician and according to IEC wiring Regulation.

2. Switch power off at the meter box and ensure that there is no power to the lamp

3. Unscrew the Fixing Cover Screws then remove the cover

4. Remove the Cable Anchorage and Terminal Block.

5. Use the plastic back box to mark the position of screw holes onto mounting surface. Drill the wall to depth of about 4 cm and fit the

wall plugs (supplied). Care should be taken to avoid drilling or screwing into concealed electrical wiring.

6. Connecting the Power Cable to the Terminal Block, see the relative symbol in Figure, ensure the cable must drill through the Cable

Gasket.

7. Affix the back box to the mounting surface with Mounting Wall Screws (supplied)

8. Re-fit the Terminal Block and Cable Anchorage.

9. Re-fit the cover.

Note:

• Please power off and let the lamp cool before touching the lamp(s), because they will become hot during lighting on.

• When adjusting lamp holders, ensure that lamps are not touching or in close proximity to sensor head

(more than 40mm), heat from the lamp(s) may distort the PIR Sensor or destroy the plastic encloser of PIR Sensor.

• Loosen lock nuts and screws on sensor and lamp before making any adjustments.

117mm

Ø6x27mm PA4x30mm

Ø88mm

Note:

-The lamp must be installed by professional electrician

-Ensure the power supply is switched off before fitting this product

184mm

29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia

Phone: 02 9554 9600 | Fax: 02 9554 9433

[email protected] | www.domuslighting.com

-Do not touch the lamp when in use

-Keep away from hot steam and corrosive gas

Installation Manual

Ø6mm

30mm

Ø88mm