American Standard Colony Soft T975.500BP Installation Instructions Manual - Page 8
Browse online or download pdf Installation Instructions Manual for Indoor Furnishing American Standard Colony Soft T975.500BP. American Standard Colony Soft T975.500BP 12 pages. Colony soft deck mount trim kit
Also for American Standard Colony Soft T975.500BP: Parts Breakdown (4 pages), Installation Instructions Manual (12 pages)
Print Page
3
MOUNT VALVE BODIES
Cut the copper outlet tubes of the VALVE BODIES as required.
(Not necessary for R810).
Insert the HOT and COLD VALVE BODIES into the TEE. (Not
necessary for R810). The HOT VALVE BODY is
marked with a red label.
Insert the VALVE BODIES and TEE through the mounting
deck from below. Assemble the VALVE LOCK RINGS so
they are flush with the top of the VALVE BODIES.
Insert the SPOUT SHANK into the TEE.
(Not necessary for R810).
Tighten the VALVE BODY and SHANK MOUNTING
NUTS securely.
Fasten the VALVE LOCK RING to the wooden mounting
surface with #8 screws (not provided).
4
SOLDER CONNECTIONS
Connect the water supply lines to the copper inlet tubes of the VALVE BODY.
Solder all TEE and WATER SUPPLY CONNECTIONS.
Remove the GUARD from the SPOUT SHANK. Assemble the 1/4" PLUG to
the SPOUT SHANK with a thread sealant.
Turn on the water supplies and check all connections for leakage.
Replace the GUARD on the SPOUT SHANK. Turn off the water supplies.
5
SERVICE
TO CHANGE THE DIRECTION OF HANDLE ROTATION
Turn off the water supplies.
Turn HANDLE to the off position.
Unscrew the VALVE LOCK NUT and remove.
A 17mm deep socket is required.
Remove the CARTRIDGE by pulling upon the SLEEVE.
Remove the SLEEVE from the CARTRIDGE.
Remove the SPRING CLIP .
Remove the STOP WASHER. Turn it 90˚ and replace.
Replace the SPRING CLIP .
Reverse the above steps to reassembly the components.
If the spout drips, operate the handles several times
from the off to the on position. Do not force - the handles only turn 90˚
VALVE LOCK RING FLUSH WITH
TOP OF THREADS ON VALVE SHANK
# 8 SCREWS
VALVE
BODY
FITTING
MOUNTING
DECK
VALVE
LOCK RING
FRICTION WASHER
MOUNTING NUT
HOT
SPOUT GUARD
1/4" PLUG
90
STOP
WASHER
VALVE
CARTRIDGE
VALVE
LOCK RING
SPOUT
SHANK
COLD
TEE
OUTLET TUBE
(CUT AS REQUIRED)
TEE
CONNECTIONS
WATER SUPPLY
CONNECTIONS
DEEP SOCKET
17mm (11/16")
VALVE
LOCK NUT
SCREW
SLEEVE
SPRING
CLIP
M 9 6 8 6 5 0 C