American Standard Wall Hung Bathroom Sink Installation Instructions

Browse online or download pdf Installation Instructions for Indoor Furnishing American Standard Wall Hung Bathroom Sink. American Standard Wall Hung Bathroom Sink 2 pages. American standard wall hung bathroom sink installation instructions

Print Page

Wall Hung Bathroom Sink

NOTE: For installation of models using concealed or exposed arms, follow instruction

provided by arms manufacturer.

Introduction: Thank you for selecting our products...products which have been the benchmarks of fine quality for years. To help

insure that the installation process will proceed smoothly, please read these instructions carefully before you begin. Also, review

the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

NOTE: Pictures may not exactly define contour of china and components.

Recommended Tools & Materials

Putty Kinfe

Pipe Wrench

Level

Channel Lock Pliers

Provide suitable reinforcement behind

finished wall for lavatory hanger mounting

screws.

Determine horizontal center line

location of support from the table listed in

Step 2. (Make sure support bottom

extends to lavatory back wall bottom.)

NOTE: If replacing an existing sink be

certain to shut off water supply before

removing old sink.

Determine the

desired rim height

(for example 32")

then select from the

Table at right the

height of the hanger

mounting bolts

centerline

EXAMPLE:

For Lucerne:

32"-1"=31"

For Ledgewood:

32"+2-7/8"=34-7/8"

INSTALLATION INSTRUCTIONS

Adjustable Wrench

Plumbers' Putty or

Caulking

Drill

C/L of 2X8

Support

Finished

Floor

TABLE

Part #

Model

0124

Comrade

0321

Declyn

0355/0356

Lucerne

0372/0373

Penlyn

4300

Ledgewood

4867/4869

Regalyn

5300

Ledgemere

RIM

HEIGHT

WASTE

FINISHED FLOOR

Tubing Cutter

Phillips Screwdriver

Hanger

Location

Distance "A"

- 2-1/2" (64mm)

- 2-3/4" (70mm)

- 1" (25mm)

- 1/8" (3mm)

+ 2-7/8" (73mm)

+ 2-3/4" (70mm)

+ 2-1/2" (64mm)

C/L OF HANGER

ANCHORING SLOTS

HANGER

HOLES FOR

ANCHOR

SCREWS

IN BACK

DRAPERY

SUPPLIES AS

REQUIRED

Basin Wrench

Tape

Measure

Hacksaw

Saber Saw

Regular Screwdriver

Position hanger according to Step 2,

making sure its center is aligned with

the waste hole centerline. Mark the

hanger screw locations through its

mounting holes.

Drill pilot holes in positioning screw

slots of hanger. (Note: Some models

are supplied with anchor screws, or

steel hangers for lavatory installations.

Other models are not provided with

mounting hardware which can be

purchased at local hardware outlets.

Lavator-ies with bottom anchor screw

holes should be secured with anchor

screws in addition to hangers.

MOUNTING SCREW

HOLES (4)

POSITIONING

SCREW SLOTS (2)

730427-100 Rev. B