American Standard Cadet Whirlpool/Bathing Pool 2772.XXXW Installation Instructions - Page 2
Browse online or download pdf Installation Instructions for Bathtubs American Standard Cadet Whirlpool/Bathing Pool 2772.XXXW. American Standard Cadet Whirlpool/Bathing Pool 2772.XXXW 4 pages. 5' x 42" whirlpool/bathing pool, high gloss acrylic shown less all fittings
Print PageINSTALLATION AND FRAMING INSTRUCTIONS
The variety of installations possible for this whirlpool may require framing procedures other than those shown. Locate studs
as required. Ensure roughing-in dimensions are proper, plumb and square. Provisions must be made in all installations for an
access opening for servicing the pump and controls. It is strongly recommended that an additional opening be provided for
access to the drain components.
NOTE: The apron should not be used as the primary access opening.
1. Position the whirlpool into the installation opening and level the deck, shimming the integral support feet as necessary.
Mark the final position of the underside of the deck by tracing a line on to the studs (see Figure 1).
2. Remove the whirlpool and attach a 2 x 4 stringer to the studs, with the top of the stringer touching the traced line.
It may be necessary to notch stringer near the SAFETY-T-HEATER blank to avoid interference, should heater be
installed at a later date.
3. Install drain components to the whirlpool following the manufacturers instructions. Before replacing your whirlpool for final
installation, be certain that an opening has been provided in the sub-floor for the drain. See the roughing-in drawing for
suggested opening size and location dimensions.
4. Replace whirlpool and re-shim the integral support feet, shimming the entire length of the support feet. Secure the shims
using construction adhesive, silicone, mortar or equivalent materials. While not a necessity, the use of a foundation base
consisting of cement (e.g. Sakrete), mortar, or grout will help provide a solid and secure installation.
FIG. 1
464mm
(18-1/4)
TYPICAL RECESS INSTALLATION
464mm
(18-1/4)
1527mm
(60-1/8)
WHIRLPOOL ONLY:
UNLESS AN ACCESS OPENING OF AT LEAST
12" X 24" (305 X 610MM) IS PROVIDED,
WARRANTY SERVICE WILL NOT BE PERFORMED.
752501-100 Rev. J
NOTCH STINGER AT
HEATER BLANK
SEE NOTE 2 ABOVE
LE V E L IN G
S TR ING E RS
610mm
(24)
BEAD
STRIP
NOTE: Tile bead kit not included and must be
TYPICAL PIER TYPE INSTALLATION
AS DESI R ED
1029mm
(40-1/2)
CUTOUT
464mm
(18-1/4)
305mm
AS DESI R ED
(12)
LEVELING
SURFACE
WATERPROOF
SEALANT
UNLESS AN ACCESS OPENING OF AT LEAST
12" X 24" (305 X 610MM) IS PROVIDED,
WARRANTY SERVICE WILL NOT BE PERFORMED.
(2)
TILE
WALLBOARD
SEALANT
TILE
ADHESIVE
LEVELING
STRINGER
purchased separately.
1486mm
CUTOUT
BATH
ACCESS PANEL
WHIRLPOOL ONLY:
BATH
NOTCH STINGER AT
HEATER BLANK
SEE NOTE 2 ABOVE
(58-1/2)
305mm
(12)
610mm
(24)