American Standard Savona Elite 2901E SERIES Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Bathtubs American Standard Savona Elite 2901E SERIES. American Standard Savona Elite 2901E SERIES 4 pages. Whirlpool, high gloss acrylic shown less all fittings

Print Page

INSTALLATION AND FRAMING INSTRUCTIONS

The variety of installations possible for this whirlpool may require framing procedures other than those shown. Locate studs

as required. Ensure roughing-in dimensions are proper, plumb and square. Provisions must be made in all installations for an

access opening for servicing the pump and controls. It is strongly recommended that an additional opening be provided for

access to the drain components.

1. Position the whirlpool into the installation opening and level the deck, shimming the integral support feet as necessary.

2. Install drain components to the whirlpool following the manufacturers instructions. Before replacing your whirlpool for final

installation, be certain that an opening has been provided in the sub-floor for the drain. See the roughing-in drawing for

suggested opening size and location dimensions.

3 . Replace whirlpool and re-shim the integral support feet, shimming the entire length of the support feet. Secure the shims

using construction adhesive, silicone, mortar or equivalent materials. While not a necessity, the use of a foundation base

consisting of cement (e.g. Sakrete), mortar, or grout will help provide a solid and secure installation.

LEVELING SURFACE

SUNKEN OR ISLAND

752867-100 Rev.D

TYPICAL PIER TYPE INSTALLATION

WATERPROOF

SEALANT

BATH

INSTALLATION

UNLESS AN ACCESS OPENING OF AT LEAST

12" X 24" (305 X 610MM) IS PROVIDED,

WARRANTY SERVICE WILL NOT BE PERFORMED.

AS D ESIR ED

42"

(1067mm)

CUTOUT

(508mm)

AS DESIR ED

ACCESS PANEL

(2)

69-3/4"

(1772mm)

CUTOUT

(305mm)

2 4

( 6 1 0 m m )