MORE SCREEN DROP
1. Place operating switch in "down" position.
2. When the screen stops, turn the white "down" limit knob (Fig. 2) one-quarter turn counterclockwise. Test by raising
picture surface approximately two feet, then lower again. Repeat until desired picture surface position is attained.
▲
!
CAUTION: Do not adjust for more drop than what was ordered. At least 1-1/2 wraps of fabric must remain on the roller. This
screen comes standard with 0" or 2" black at the top. See the specification data sheet for details.
LESS SCREEN DROP
1. Raise picture surface approximately two feet above desired level.
2. Place operating switch in "off"position.
3. Turn the white "down" limit switch (Fig. 2) one-quarter turn clockwise. Test by raising picture surface
approximately two feet, then lower again. Repeat until desired picture surface position is attained.
ADVANTAGE
®
DELUXE ELECTROL
NOTE: Electrical connections on left end of
case.
120V WIRING DIAGRAM
WITH ONBOARD LVC
120VAC 60HZ
INPUT
NOTE: Electrical connections on left end of
case.
220 / 240V WIRING DIAGRAM
WITH ONBOARD LVC
LOW-VOLTAGE
WALL SWITCH
OPTIONAL RF OR IR
REMOTE CONNECTOR
220/240VAC 50/60HZ
INPUT
®
INSTRUCTIONS
LOW-VOLTAGE
WALL SWITCH
BLACK AND YELLOW
BLACK
OPTIONAL RF OR IR
WHITE
REMOTE CONNECTOR
UP
RED
STOP
DOWN
BLACK
WHITE
UP
RED
STOP
DOWN
LVC BOARD
RED
BLACK
WHITE
DOOR SWITCH
BLACK
INPUT
GROUND
BLACK (HOT)
WHITE (COMMON)
WHITE (COMMON)
BLACK (DOWN)
RED (UP)
LVC BOARD
BLACK
BROWN
BLUE
DOOR SWITCH
BROWN AND
YELLOW
INPUT
BROWN
GROUND
BLACK
BROWN (HOT)
BLUE
BLACK
BROWN (DOWN)
BLACK (UP)
3
WHITE
RED (UP)
GRAY
BLACK (DOWN)
GREEN
SCREEN MOTOR
BLACK (CLOSE)
WHITE
RED (OPEN)
GREEN
DOOR MOTOR
BLUE
BLACK (UP)
GRAY
BROWN (DOWN)
GREEN
SCREEN MOTOR
BROWN (CLOSE)
BLUE
BLACK(OPEN)
GREEN
DOOR MOTOR
Print Page