Da-Lite Tensioned Large Advantage Deluxe Electrol Instruction Book - Page 2

Browse online or download pdf Instruction Book for Projector Accessories Da-Lite Tensioned Large Advantage Deluxe Electrol. Da-Lite Tensioned Large Advantage Deluxe Electrol 8 pages.

Print Page

Important Safety Instructions

When using your video equipment, basic safety precautions

should always be followed, including the following:

Read and understand all instructions before using.

2. Close supervision is necessary when any appliance is used

by or near children. Do not leave appliance unattended while

in use.

3. Do not operate appliance with a damaged cord or if the

appliance has been dropped or damaged – until it has been

examined by a qualified serviceman.

4. Position the cord so that it will not be tripped over, pulled, or

contact hot surfaces.

5. If an extension cord is necessary, a cord with a current rating

at least equal to that of the appliance should be used. Cords

rated for less amperage than the appliance may overheat.

6. To reduce the risk of electric shock, do not immerse this

appliance in water or other liquids.

7. To reduce the risk of electric shock, do not disassemble this

appliance. Contact an authorized service dealer when repair

work is required. Incorrect reassembly can cause electric

shock when the appliance is used subsequently.

8. The use of an accessory attachment not recommended by

the manufacturer may cause a risk of fire, electric shock, or

injury to persons.

Save These Instructions

Pre-Installation

1. Carefully unpack screen and remove outer wrapping

from case.

2. Make sure to recheck measurements of screen location

before installation.

PLEASE NOTE: Motor Operator Projection Screen Models

LADT, LADDT, LAD and LADD must be installed in accordance

with the requirements of the Local Building Codes, the

Canadian Electrical Code (CEC), CAN/CSA C22.1 and the

National Electric Code (NEC), NFPA 70. An appropriate

disconnect device shall be provided as part of the building

installation.

Bolts

Figure 1

Case Installation

1. The case provides multiple attachment points for bolts,

cables, or threaded rod. Page 5 shows threaded rod installed.

The variable position-mounting bracket may be located

anywhere along the length of the case. It is recommended to

keep the brackets spaced evenly enough to distribute the

weight of the screen. One mounting bracket is required for

every 4' of case length.

The case has a self-trimming flange around the bottom.

Ceiling tiles or drywall may be placed on top of this flange to

provide a finished appearance.

2. After securing the case in the ceiling check that the case is

level and plumb.

3. Use supplied 1/8" nex key to remove silver shipping brackets

attached to slat and screen case.

4. Install electrical connections that apply to your unit. Review

the wiring diagrams on page 4 for proper installation..

Door Support Screws

(Not All Sizes)

Access

Door