Da-Lite THEATER-LITE Operating Instructions

Browse online or download pdf Operating Instructions for Projector Da-Lite THEATER-LITE. Da-Lite THEATER-LITE 2 pages.

Print Page

INTRODUCTION

Thank you for purchasing this Da-Lite product. Before operating your screen, please read all instructions.

Store this instruction book for future reference.

FOR YOUR SAFTY

This product has been designed with safety in mind. However inappropriate use of this product is dan-

gerous and may cause personal injury. In order to prevent accidents, please follow the instructions

below.

Inspect the product regularly.

Before you use the projection screen, make certain that all the parts

such as the screen case, hook, upright bar, feet and lifiing handle are

not warped, Ioose, or damaged. Do not use if screen is out of order.

CAUTION

Avoid touching the screen films while raising or lowering of unit.

Do not set up the screen on an unstable or uneven surface. This may cause the screen to fall or tip over,

resulting in damage to the screen or personal injury. Be especially careful when setting up where small

children may be present. Do not let children operate or play with the screen.

Do not place the screen near any heating sources. Since the screen is made of a plastic material, it can

be damaged by heat.

Do not disassemble the screen. This will void your warranty and may cause injury.

After the screen is set up, do not push or lean against the upright bar. Do not hang anyihing from the

screen or the upright bar.

CARE OF SCREEN

Do not leave the screen in areas subject to high humidity and direct sunlight.

Keep the projection suface of the screen free from dirt and dust

If the screen becomes dirty, Iightly wipe it off with soft cloth moistened in a mild solu-

tion of a mild neutral detergent and water. Benzine, thinner and other volatile agents can cause perma-

nent damage to the screen and should never be used for cleaning.

Do not write on the screen film.

Do not set up the screen in areas subject to strong breeze. This may cause the screen to move and in-

terfere with the quality of the projected image.

Before storing the screen, Iock the release lever by rotating green knob. Do not carry the screen if the

release lever and the green knob are not completely locked. Doing so may cause the screen case to slip

off and discolor or damage the screen.

Operating Instructions

Setting up the screen

1 Determine where to set up the screen.

2 Rotate feet at the bottom of the case so

they are perpendicular to the case.

3 Rotate the upright bar 90 degrees verti-

cally until it clicks.

4 Raise the telescopic upright bar (small) to

the desired hight.

5 Raise the telescopic upright bar (medium)

to the desired hight. The height can be

adjusted to 4 different levels.

6 Rotate the hook at the top of the upright

bar 90 degrees horizontally.

7 Unlock the release lever by rotating the

green knob 90 degrees.

8 Raise the screen by grasping the lifting

handle while simultaneously squeezing

the release latches.

9 Anchor the lifting handle on the upright

hook.

Make sure that the notch of the handre is

firmly on the hook .

Storing the screen

1 Remove the lifting handle from the hook.

2 Grasp the lifting handle, lower the screen,

and allow it retract into the case.

Lower the screen, as straight as possile, until

it clicks and the screen is completely stowed

and locked in the case.

Do not carry the product while the screen is

not completely stowed and locked. Doing so

may cause the case to accidentally slip off

and discolor or damage the product.

Green knob