American Standard Studio Cadet 3 2589 Installation Instructions Care And Maintenance - Page 9

Browse online or download pdf Installation Instructions Care And Maintenance for Toilets American Standard Studio Cadet 3 2589. American Standard Studio Cadet 3 2589 13 pages. 2-piece round front, elongated, right height toilets
Also for American Standard Studio Cadet 3 2589: Installation Instructions (4 pages)

Print Page

LIFT ARM

FIRST

IMPORTANT: Always clear

sand and rust from system.

• Make sure water supply is

off. Remove valve TOP by

lifting arm and rotating top

and arm 1/8 turn

counterclockwise, pressing

down slightly on cap.

Always use quality Fluidmaster repair parts when maintaining your Fluidmaster products.

Fluidmaster shall not be responsible or liable for any damages caused by products used

with Fluidmaster valves that were not manufactured by Fluidmaster, Inc.

PROBLEM

Does not flush

a. Water supply valve closed.

b. Supply line blocked.

c. Flush valve chain too loose or disconnected.

d. Sand or debris lodged in water control.

Poor or sluggish flush

a. Bowl water level too low.

b. Supply valve partly closed.

c. Partially clogged trapway and/or drain pipe and/or vent.

d. Supply pressure too low.

Toilet leaks

a. Poor supply line connection.

b. Poor bowl to tank/floor connection.

Toilet does not shut off

a. Flush valve chain too tight, holding flush valve open.

b. Flush valve seat and/or flapper worn or deformed.

c. Sand or debris lodged in water control.

In the United States:

American Standard Brands

P.O. Box 6820

Piscataway, New Jersey 08855

Attention: Director of Customer Care

For residents of the United States, warranty

information may also be obtained by calling

the following toll free number: (800) 442-1902

www.americanstandard.com

• While holding a container

• Replace TOP by engaging

over the uncapped VALVE

to prevent splashing, turn

water supply on and off a

few times. Leave water

supply off.

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE

Toll Free: (800) 387-0369

www.americanstandard.ca

IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK

SLOWLY, repeat Step 13.

IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF

NON-USE, it is a signal you are wasting water because:

• The end of the refill tube is inserted into overflow pipe, below

• The flush valve is leaking because it's worn, dirty or

IF FILL VALVE WON'T TURN ON OR SHUT OFF or REFILL OF

TANK WATER IS SLOW after valve has been in use for some

time, Fluidmaster Model 242 Replacement Seal may be needed.

Go to our website at www.fluidmaster.com for more solutions

to toilet problems.

lugs and rotating 1/8 turn

clockwise. MAKE CERTAIN

TIP IS TURNED TO THE

LOCKED POSITION. VALVE

MAY NOT TURN ON IF TOP

IS NOT FULLY TURNED TO

THE LOCKED POSITION.

a. Open valve and allow water to fill tank.

b. Shut off water supply, disconnect supply line and inspect all gaskets and

washers. Reassemble. Also, see Fluidmaster maintenance. (see Step 13)

c. Readjust chain length as required.

d. Shut off water supply. Remove cap and clean as per Step 13.

a. Check that refill tube is connected to water control and inserted into tank

overflow without being kinked or damaged.

b. Open supply valve fully. Be sure that proper supply tube size is used.

c. Remove obstruction. Consult a plumber if necessary.

d. Normal supply pressure must be at least 20 psi.

a. Review Step 9 of installation procedure.

b. Review Step 4 through 7 of installation procedure.

a. Readjust chain length as needed. Review Step 10.

b. Shut off water supply. Replace flush valve.

c. Shut off water supply. Remove cap and clean per Step 13.

In Canada:

AS Canada, ULC

5900 Avebury Rd.

Mississauga, Ontario

Canada L5R 3M3

- 4 -

TROUBLESHOOTING

water level in tank. Attach refill tube to overflow pipe using "S"

clip provided.

misaligned with tank ball or flapper (replace with a new flapper).

For troubleshooting information please contact:

30800 Rancho Viejo Road

San Juan Capistrano, CA 92675

(949) 728-2000 (800) 631-2011

www.fluidmaster.com

® Registered trademark of Fluidmaster, Inc.

CORRECTIVE ACTION

In Mexico:

American Standard B&K Mexico

S. de R.L. de C.V.

Via Morelos #330

Col. Santa Clara

Ecatepec 55540 Edo. Mexico

Toll Free: 01-800-839-1200

www.americanstandard.com.mx

7 3 013 7 1- 10 0 Rev. E