American Standard TF-4516 Installation Manual - Page 3
Browse online or download pdf Installation Manual for Toilets American Standard TF-4516. American Standard TF-4516 7 pages. Close-coupled
Print Page
Connect the waste connector into the toilet
Installing the toilet with the floor
Lift the toilet assembly and install
by assemblings the outlet edge of
waste connector with the waste inlet
as the mark defined.
Install the water supply hose
Attach the water supply hose properly
to the water control valve of the tank.
And then tighten snugly by hand.
Attach The Water Supply Hose To The Stop Valve
Attach the water supply hose to
the stop valve. And then tighten
snugly by hand. Turn on the water
to test for leakage occurs, use a
wrench to tighten the connection
carefully untill the leakage stops.
After the installation with above
instruction, check the levelness
with the use of level gauge from
side to side (left & right)
Attaching the tank
Water Level Adjustment
Fixing the toilet with the floor
By using the screw with the floor fixing set
(supplied)
¹Ó¶Ñ § ¾Ñ ¡ ¹é Ó ·Õ è » ÃСͺÍØ » ¡Ã³ì ¶ Ñ § ¾Ñ ¡ ¹é Ó àÃÕ Â ºÃé Í ÂáÅé Ç µÒÁÇÔ ¸ Õ ¡ ÒÃ·Õ è á ¹Ð¹Ó
äÇé Ê ÓËÃÑ º ÍØ » ¡Ã³ì Ã Ø è ¹ ¹Ñ é ¹ æ â´Â¡ÒÃãªé ¹ ç Í µÂÖ ´ ÃÐËÇè Ò §ÃÙ ¶ Ñ § ¾Ñ ¡ ¹é Ó áÅÐâ¶Êé Ç Á
´é Ò ¹ã¹â´ÂÁÕ Â Ò§Ãͧ¶Ñ § ¾Ñ ¡ ¹é Ó µÃ§µÓáË¹è § ·Ò§¹é Ó Å§¢Í§¶Ñ § ¾Ñ ¡ ¹é Ó ¢Ñ ¹ ¹ç Í µ
ÂÖ ´ ÊÅÑ º ¡Ñ ¹ 2 ¨Ø ´ ´é Ç ÂÁ× Í ¨¹á¹è ¹ áÅÐãªé » ÃÐá¨¢Ñ ¹ ÂÖ ´ ¹ç Í µ·Ñ é § 2 ¨Ø ´
ÍÕ ¡ ¤ÃÑ é § ¤ÇÃÃÐÇÑ § ¡ÒÃ¢Ñ ¹ á¹è ¹ à¡Ô ¹ ä» à¾ÃÒШзÓãËé ¶ Ñ § ¾Ñ ¡ ¹é Ó áÅÐâ¶Êé Ç Á
ºÃÔ à dz¹Ñ é ¹ ᵡä´é áÅФÇÃãËé ¶ Ñ § ¾Ñ ¡ ¹é Ó ä´é Ã Ð´Ñ º äÁè à ͹àÍÕ Â §
Gather all the components first. Insert the rubber gasket
in the water outlet hole, then place the tank over it,
ensuring a secure fit. Next, place a rubber washer on
each of the 2 bolts and insert these through their respective
holes. Place the washer and the nut on the end of the bolt
tighten alternately one side, then the other untill snug. Be
sure the tank is level. Do not tighten the nuts too much.
it will break the vitreous china.
Adjust the water level in the tank to
point indicated on the tank wall,
as shown in the picture.
The picture shows
the completely connector
into toilet.