Daavlin DT Home-Control Operation Manual - Page 16

Browse online or download pdf Operation Manual for Medical Equipment Daavlin DT Home-Control. Daavlin DT Home-Control 19 pages. Modes of operation - timed mode

Print Page

Emissions Test

Power frequency magnetic

field immunity test following

IEC 61000-4-8

Voltage dips and interruptions

immunity test following IEC

61000-4-11

The device is intended for use in the electromagnetic environment specified below. The

customer or the user of the device should assure that it is used in such an environment.

IEC 60601

Immunity test

test level

Conducted RF

3 Vrms

IEC 61000-4-6

150 kHz to

80 MHz

Radiated RF

3 V/m

IEC 61000-4-3

80 MHz to

2.5 GHz

NOTE 1: At 80 MHz and 800 MHz, the higher frequency range applies.

NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is

affected by absorption and reflection from structures, objects and people

MNL-00049 [1]

IEC 60601 Test Level

50 Hz, 30 A/m

30% Reduction for 500

mS at 0 degrees,

100% Interruption for 10

mS at 0, 45, 90, 135, 180,

225, 270,315 degrees,

100% Interruption at 5000

mS at 0 degrees

Table 5 Electromagnetic Immunity

Compliance

level

3 Vrms

3 V/m

Proprietary and Confidential. Printed copies will not be updated.

Actual Level

50 Hz, 30 A/m

30% Reduction for 500 mS at

0 degrees,

100% Interruption for 10 mS

at 0, 45, 90, 135, 180, 225,

270,315 degrees,

100% Interruption at 5000

mS at 0 degrees

Electromagnetic environment - guidance

Portable and mobile RF communications

equipment should be used no closer to any

part of the device, including cables, than the

recommended separation distance calculated

from the equation applicable to the frequency

of the transmitter.

Recommended separation distance

= 1.2√

= 1.2 √ 80 MHZ to 800 MHz

= 2.3 √ 800 MHz to 2.5 GHz

where P is the maximum output power rating

of the transmitter in watts (W) according to

the transmitter manufacturer and d is the

recommended separation distance in meters

(m).

Field strengths from fixed RF transmitters, as

determined by an electromagnetic site survey,

should be less than the compliance level in

each frequency range.

Interference may occur in the vicinity of

equipment marked with the following symbol:

Page 16 of 19