Daavlin 7 Series Operation Manual - Page 4

Browse online or download pdf Operation Manual for Lantern Daavlin 7 Series. Daavlin 7 Series 13 pages. Integrated dosimetry with link control
Also for Daavlin 7 Series: Installation Manual (2 pages)

Print Page
Daavlin 7 Series Operation Manual
2. Remove all of the packing material from the container, making sure that all parts and accessories are
accounted for. You will find the following parts/accessories:
Protective Goggles (1 pair)
•
Feet (2) – Figure 1
•
Stabilizer Bars (2) – Figure 2
•
Grid
•
Power Cord
•
Figure 1
3. The screws to attach the feet are pre-inserted in the bottom of the unit at the factory. Using a #2 Philips
screwdriver, remove the screws, then position the first foot so that its "longer" side is toward the front (the
lamp side of the device). Mount it using the screws that you removed from the bottom of the device.
Repeat the process for the second foot.
4. Using two people if available, leaving the device on its side, but with the feet attached, gently tilt the device
upward until both feet are on the floor.
5. Remove the foam shock absorbers and the plastic wrap.
6. Mount the two stabilizer brackets. The screws for mounting the brackets are pre-inserted into the unit 14"
(35cm) from the bottom of the unit and in each foot. Using a #2 Philips screwdriver, remove the screws,
position the brackets and then replace the screws.
MANU0140
Rev. 0
2/2019
Figure 2
4