American Time SiteSync IQ Installation And Operation Manual - Page 12

Browse online or download pdf Installation And Operation Manual for Transmitter American Time SiteSync IQ. American Time SiteSync IQ 13 pages. Wireless system controller with standard gps & magnetic mount tx antenna
Also for American Time SiteSync IQ: Quick Start Installation Manual (2 pages), Installation And Operation Manual (2 pages), Installation And Operation Manual (7 pages), Installation And Operation Manual (6 pages), Quick Start Installation Manual (2 pages), Quick Start Installation Manual (2 pages), Quick Start Installation Manual (2 pages), Quick Start Installation Manual (2 pages), Quick Start Installation Manual (2 pages), Quick Start Installation Manual (2 pages), Quick Start Manual (2 pages), Quick Start Manual (2 pages), Quick Start Manual (2 pages)

Print Page

Appendix C: Clock Relay

Wiring Diagram

Wired Clock Circuit Installation

To install wired clock circuits:

1. Disconnect and lock out power to the SiteSync IQ Wireless Controller and any circuit wiring.

2. Remove the cover from the Wireless Controller.

a. Remove 2 screws from each side of the wire compartment cover.

b. Remove the wire compartment cover.

3. Route clock circuit wires into the wiring compartment of the Wireless Controller.

a. Remove knockout(s) below wire compartment.

b. Use copper conductors only.

c. Use strain relief connector fittings in the knockout holes to secure the wires.

d. Route the wires into the wiring compartment, leaving enough slack to make all connections to the relay terminals.

4. Connect clock wires to the circuit relay terminals.

5. Replace the wire compartment cover.

6. Apply power to the wireless controller and clock circuit(s).

7. Test the clock circuit. Clock relay B should activate at HH:57:54 for 8 seconds and at 05:57:54 for 14 seconds.

120/24 VAC

AC RTN

BELL 5/CLK A

Clock Code 01 - 3 wire Synchronous

BELL 6/CLK B

SiteSync IQ Wireless Controller

Installation Manual

RUN MOTOR

RETURN

CORRECTION