Dongguan Xin Bao Instrument SBT401 Operation Manual - Page 9

Browse online or download pdf Operation Manual for Test Equipment Dongguan Xin Bao Instrument SBT401. Dongguan Xin Bao Instrument SBT401 16 pages. Abrasion and pilling tester

Print Page
Dongguan Xin Bao Instrument Co., Ltd

3.2 Assembly for Pilling Testing

1.
Place the machine on a firm and level bench.
2.
Position the bearings on the inner and outer peg drive wheels such that the total stroke of all
the pegs is reduced to 24mm .
This is achieved by moving the bearing support block to position B. It is important to note that
each block is numbered A, Bor C. Each block must therefore be fitted to the corresponding
numbered wheel drive.
To convert back for abrasion testing, the bearing support blocks are moved to position C.
3.
Separate the spindles from the abrasion sample holders.
4.
Push the long spindles into the pilling sample holders which are alloy with a diameter of
90mm.
5.
Place the three balls into the three cups and lower the motion plate over the three bearings to
rest on the three balls.
6.
The underside of the motion plate is fitted with three steel bearing plates and it is essential that
the three steel balls are placed directly between the cups and the steel bearing plates.
7.
Connect to the electricity supply with the cable supplied.

SECTION 4 OPERATING INSTRUCTIONS FOR THE SBT401

4.1 Operation
1.
Ensure that the machine is connected to the mains supply and the "on" switch at the front of
the machine is switched on. The power on light will illuminate.
Add: The 3rd Industrial Zone, Chashan Town, Dongguan. Tel: 0769-33365786 www.ots-testequipment.net
7