Astonica 50101033 Instruction Manual - Page 2
Browse online or download pdf Instruction Manual for Indoor Furnishing Astonica 50101033. Astonica 50101033 2 pages. Cast aluminum lounger
PARTS & HARDWARE LIST
PART #
DESCRIPTION
A
Seat
B
Backrest
C
Front Leg
D
Armrest Assembly
E
Wheel
F
Backrest Support Bar
Axle
G
8mm x 40 Screw
H
8mm x 35 Stud
I
J
8mm x 30 Stud
K
6mm x 45 Screw
L
8mm Flat Washer
M
8mm Lock Washer
N
8mm Hex Nut
8mm Hex Cap Nut
O
P
6mm Flat Washer
Q
6mm Lock Washer
R
6mm Hex Cap Nut
S
16mm Flat Washer
T
8mm Flat Washer
Carefully remove the contents from the package.
If any parts are missing do not attempt to use the product until they have
been obtained and correctly installed.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-422-7800.
QUANTITY
1
1
2
2
2
1
1
6
6
2
2
6
12
6
2
2
2
2
2
2
2
E
D
A
I
C
L M
N
C
ASSEMBLY INSTRUCTIONS
1. Turn the seat (A) upside down on a non-scratching surface. Attach the front
legs (C) to the seat (A) by threading (6) 8mm x 35 studs (I) into the holes under
the front end of the seat (A). Place the legs (C) over the studs (I) and secure
them in place with (6) 8mm flat washers (L), lock washers (M), and hex nuts (N).
2. Insert the axle (G) into both armrest assemblies (D). Then, align the holes in the
sides of the armrest assemblies (D) with those in the sides of the seat (A).
Secure them together with (2) 8mm x 40 screws (H) and lock washers (M) on
each side, screwing them in from the outside.
3. Slide a wheel (E) onto the axle (G). Screw in an 8mm x 30 stud (J), then place a
16mm flat washer (S), 8mm lock washer (M) and hex cap nut (O) on the end to
secure the wheel (E) in place. Repeat this procedure with the other wheel (E).
4. Attach the backrest (B) to the armrest (D) with an 8mm x 45 screw (H) and flat
washer (T) on each side, screwing them in from the outside.
5. Attach the backrest support bar (F) to the backrest (B) using a 6mm x 45 screw
(K), flat washer (P), lock washer (Q) and hex cap nut (R).
6. Adjust the inclination of the backrest (B) by placing the backrest support bar (F)
in the desired notch on the back of the armrest assembly (D).
B
R
Q
P
F
G
M
H
D
T
M
H
H
J
S M
3
K
E
O